pinctrl: sh-pfc: Do not overwrite bias configuration

After the last user of the in_pd/in_pu bias parameters of the _PCRH()
macro was removed in commit 80da8e02 ("sh-pfc: r8a7740: Add bias
(pull-up/down) pinconf support"), bias parameters are supposed to be
configured using the generic pinctl mechanism, which calls the
.set_bias() method.

However, the PORTCR() macro still represents the control register as
consisting of two 4-bit fields. Hence the bias configuration in the
uppermost 2 bits is always overwritten with zeroes when a pin is
configured for GPIO, disabling any previously configured bias.

Use the variable config register macro instead, to represent the
register as having 4 fields, and to make sure only the input/output
control and function fields are touched.

This affects R-Mobile APE6 (r8a73a4), R-Mobile A1 (r8a7740), SH-Mobile
AP4 (sh7372), and SH-Mobile AG5 (sh73a0).
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/sh-pfc/sh_pfc.h

@@ -302,20 +302,21 @@ struct sh_pfc_soc_info {
 /*
  * PORTnCR macro
  */
-#define _PCRH(in, in_pd, in_pu, out)	\
-	0, (out), (in), 0,		\
-	0, 0, 0, 0,			\
-	0, 0, (in_pd), 0,		\
-	0, 0, (in_pu), 0
-
 #define PORTCR(nr, reg)							\
 	{								\
-		PINMUX_CFG_REG("PORT" nr "CR", reg, 8, 4) {		\
-			_PCRH(PORT##nr##_IN, 0, 0, PORT##nr##_OUT),	\
+		PINMUX_CFG_REG_VAR("PORT" nr "CR", reg, 8, 2, 2, 1, 3) {\
+			/* PULMD[1:0], handled by .set_bias() */	\
+			0, 0, 0, 0,					\
+			/* IE and OE */					\
+			0, PORT##nr##_OUT, PORT##nr##_IN, 0,		\
+			/* SEC, not supported */			\
+			0, 0,						\
+			/* PTMD[2:0] */					\
 			PORT##nr##_FN0, PORT##nr##_FN1,			\
 			PORT##nr##_FN2, PORT##nr##_FN3,			\
 			PORT##nr##_FN4, PORT##nr##_FN5,			\
-				PORT##nr##_FN6, PORT##nr##_FN7 }	\
+			PORT##nr##_FN6, PORT##nr##_FN7			\
+		}							\
 	}
 
 #endif /* __SH_PFC_H */