pinctrl: baytrail: Move default strength assignment to a switch-case

When ->pin_config_set() is called from the GPIO library (assumed
GpioIo() ACPI resource), the argument can be 1, when, for example,
PullDefault is provided. In such case we supply sane default in
the driver. Move that default assingment to a switch-case, so
it will be consolidated in one place.
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>

drivers/pinctrl/intel/pinctrl-baytrail.c

@@ -810,6 +810,7 @@ static int byt_set_pull_strength(u32 *reg, u16 strength)
 	*reg &= ~BYT_PULL_STR_MASK;
 
 	switch (strength) {
+	case 1: /* Set default strength value in case none is given */
 	case 2000:
 		*reg |= BYT_PULL_STR_2K;
 		break;
@@ -957,10 +958,6 @@ static int byt_pin_config_set(struct pinctrl_dev *pctl_dev,
 			conf &= ~BYT_PULL_ASSIGN_MASK;
 			break;
 		case PIN_CONFIG_BIAS_PULL_DOWN:
-			/* Set default strength value in case none is given */
-			if (arg == 1)
-				arg = 2000;
-
 			byt_gpio_force_input_mode(vg, offset);
 
 			conf &= ~BYT_PULL_ASSIGN_MASK;
@@ -969,10 +966,6 @@ static int byt_pin_config_set(struct pinctrl_dev *pctl_dev,
 
 			break;
 		case PIN_CONFIG_BIAS_PULL_UP:
-			/* Set default strength value in case none is given */
-			if (arg == 1)
-				arg = 2000;
-
 			byt_gpio_force_input_mode(vg, offset);
 
 			conf &= ~BYT_PULL_ASSIGN_MASK;