staging: comedi: addi_apci_1710: only pci bar 2 is used

This driver used to be tied to the addi-data common code which
always saved the start address of pci bars 0, 1, 2, and 3 for
use by the driver. This driver only uses pci bar 2.

Remove all the non-used pci bars and move the saving of pci bar
2 so it occurs right after the pci device is enabled.
Signed-off-by: H Hartley Sweeten <hsweeten@visionengravers.com>
Cc: Ian Abbott <abbotti@mev.co.uk>
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/comedi/drivers/addi_apci_1710.c

@@ -45,16 +45,7 @@ static int apci1710_auto_attach(struct comedi_device *dev,
 	ret = comedi_pci_enable(dev);
 	if (ret)
 		return ret;
-
-	if (this_board->i_IorangeBase1)
-		dev->iobase = pci_resource_start(pcidev, 1);
-	else
-		dev->iobase = pci_resource_start(pcidev, 0);
-
-	devpriv->iobase = dev->iobase;
-	devpriv->i_IobaseAmcc = pci_resource_start(pcidev, 0);
-	devpriv->i_IobaseAddon = pci_resource_start(pcidev, 2);
-	devpriv->i_IobaseReserved = pci_resource_start(pcidev, 3);
+	devpriv->s_BoardInfos.ui_Address = pci_resource_start(pcidev, 2);
 
 	if (pcidev->irq > 0) {
 		ret = request_irq(pcidev->irq, v_ADDI_Interrupt, IRQF_SHARED,
@@ -65,8 +56,6 @@ static int apci1710_auto_attach(struct comedi_device *dev,
 
 	i_ADDI_AttachPCI1710(dev);
 
-	devpriv->s_BoardInfos.ui_Address = pci_resource_start(pcidev, 2);
-
 	i_APCI1710_Reset(dev);
 	return 0;
 }