drm/i915: Fix hotplug irq ack on i965/g4x

Just like with PIPESTAT, the edge triggered IIR on i965/g4x
also causes problems for hotplug interrupts. To make sure
we don't get the IIR port interrupt bit stuck low with the
ISR bit high we must force an edge in ISR. Unfortunately
we can't borrow the PIPESTAT trick and toggle the enable
bits in PORT_HOTPLUG_EN as that act itself generates hotplug
interrupts. Instead we just have to loop until we've cleared
PORT_HOTPLUG_STAT, or we just give up and WARN.

v2: Don't frob with PORT_HOTPLUG_EN

Cc: stable@vger.kernel.org
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20180614175625.1615-1-ville.syrjala@linux.intel.comReviewed-by: Imre Deak <imre.deak@intel.com>

drivers/gpu/drm/i915/i915_irq.c

@@ -2069,10 +2069,38 @@ static void valleyview_pipestat_irq_handler(struct drm_i915_private *dev_priv,
 
 static u32 i9xx_hpd_irq_ack(struct drm_i915_private *dev_priv)
 {
-	u32 hotplug_status = I915_READ(PORT_HOTPLUG_STAT);
+	u32 hotplug_status = 0, hotplug_status_mask;
+	int i;
+
+	if (IS_G4X(dev_priv) ||
+	    IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv))
+		hotplug_status_mask = HOTPLUG_INT_STATUS_G4X |
+			DP_AUX_CHANNEL_MASK_INT_STATUS_G4X;
+	else
+		hotplug_status_mask = HOTPLUG_INT_STATUS_I915;
 
-	if (hotplug_status)
+	/*
+	 * We absolutely have to clear all the pending interrupt
+	 * bits in PORT_HOTPLUG_STAT. Otherwise the ISR port
+	 * interrupt bit won't have an edge, and the i965/g4x
+	 * edge triggered IIR will not notice that an interrupt
+	 * is still pending. We can't use PORT_HOTPLUG_EN to
+	 * guarantee the edge as the act of toggling the enable
+	 * bits can itself generate a new hotplug interrupt :(
+	 */
+	for (i = 0; i < 10; i++) {
+		u32 tmp = I915_READ(PORT_HOTPLUG_STAT) & hotplug_status_mask;
+
+		if (tmp == 0)
+			return hotplug_status;
+
+		hotplug_status |= tmp;
 		I915_WRITE(PORT_HOTPLUG_STAT, hotplug_status);
+	}
+
+	WARN_ONCE(1,
+		  "PORT_HOTPLUG_STAT did not clear (0x%08x)\n",
+		  I915_READ(PORT_HOTPLUG_STAT));
 
 	return hotplug_status;
 }