microblaze: Fix msr instruction detection

Fix msr instructions detection. The current code
just use msrclr for loading msr content and compare
it with proper MSR content. If msrclr is not implemented
r8 contains pc address.
Previous code wanted to use MSR carry bit but if msrclr
wasn't implemented carry wasn't cleared.
Signed-off-by: Michal Simek <monstr@monstr.eu>

arch/microblaze/kernel/head.S

@@ -62,15 +62,14 @@ real_start:
 	andi	r1, r1, ~2
 	mts	rmsr, r1
 /*
- * Here is checking mechanism which check if Microblaze has msr instructions
- * We load msr and compare it with previous r1 value - if is the same,
- * msr instructions works if not - cpu don't have them.
+ * According to Xilinx, msrclr instruction behaves like 'mfs rX,rpc'
+ * if the msrclr instruction is not enabled. We use this to detect
+ * if the opcode is available, by issuing msrclr and then testing the result.
+ * r8 == 0 - msr instructions are implemented
+ * r8 != 0 - msr instructions are not implemented
  */
-	/* r8=0 - I have msr instr, 1 - I don't have them */
-	rsubi	r0, r0, 1	/* set the carry bit */
-	msrclr	r0, 0x4		/* try to clear it */
-	/* read the carry bit, r8 will be '0' if msrclr exists */
-	addik	r8, r0, 0
+	msrclr	r8, 0 /* clear nothing - just read msr for test */
+	cmpu	r8, r8, r1 /* r1 must contain msr reg content */
 
 /* r7 may point to an FDT, or there may be one linked in.
    if it's in r7, we've got to save it away ASAP.

arch/microblaze/kernel/setup.c

@@ -161,11 +161,11 @@ void __init machine_early_init(const char *cmdline, unsigned int ram,
 #if CONFIG_XILINX_MICROBLAZE0_USE_MSR_INSTR
 	if (msr)
 		eprintk("!!!Your kernel has setup MSR instruction but "
-				"CPU don't have it %d\n", msr);
+				"CPU don't have it %x\n", msr);
 #else
 	if (!msr)
 		eprintk("!!!Your kernel not setup MSR instruction but "
-				"CPU have it %d\n", msr);
+				"CPU have it %x\n", msr);
 #endif
 
 	for (src = __ivt_start; src < __ivt_end; src++, dst++)