Commit 0f741d99 authored by Samuel Ortiz's avatar Samuel Ortiz Committed by John W. Linville

iwl3945: Getting rid of iwl3945_eeprom_channel

The corresponding iwl structure is identical.
Signed-off-by: default avatarSamuel Ortiz <samuel.ortiz@intel.com>
Signed-off-by: default avatarAbhijeet Kolekar <abhijeet.kolekar@intel.com>
Signed-off-by: default avatarReinette Chatre <reinette.chatre@intel.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent a3139c59
......@@ -69,6 +69,8 @@
#ifndef __iwl_3945_hw__
#define __iwl_3945_hw__
#include "iwl-eeprom.h"
/*
* uCode queue management definitions ...
* Queue #4 is the command queue for 3945 and 4965.
......@@ -85,55 +87,8 @@
/*
* EEPROM related constants, enums, and structures.
*/
/*
* EEPROM access time values:
*
* Driver initiates EEPROM read by writing byte address << 1 to CSR_EEPROM_REG,
* then clearing (with subsequent read/modify/write) CSR_EEPROM_REG bit
* CSR_EEPROM_REG_BIT_CMD (0x2).
* Driver then polls CSR_EEPROM_REG for CSR_EEPROM_REG_READ_VALID_MSK (0x1).
* When polling, wait 10 uSec between polling loops, up to a maximum 5000 uSec.
* Driver reads 16-bit value from bits 31-16 of CSR_EEPROM_REG.
*/
#define IWL_EEPROM_ACCESS_TIMEOUT 5000 /* uSec */
/*
* Regulatory channel usage flags in EEPROM struct iwl_eeprom_channel.flags.
*
* IBSS and/or AP operation is allowed *only* on those channels with
* (VALID && IBSS && ACTIVE && !RADAR). This restriction is in place because
* RADAR detection is not supported by the 3945 driver, but is a
* requirement for establishing a new network for legal operation on channels
* requiring RADAR detection or restricting ACTIVE scanning.
*
* NOTE: "WIDE" flag indicates that 20 MHz channel is supported;
* 3945 does not support FAT 40 MHz-wide channels.
*
* NOTE: Using a channel inappropriately will result in a uCode error!
*/
enum {
EEPROM_CHANNEL_VALID = (1 << 0), /* usable for this SKU/geo */
EEPROM_CHANNEL_IBSS = (1 << 1), /* usable as an IBSS channel */
/* Bit 2 Reserved */
EEPROM_CHANNEL_ACTIVE = (1 << 3), /* active scanning allowed */
EEPROM_CHANNEL_RADAR = (1 << 4), /* radar detection required */
EEPROM_CHANNEL_WIDE = (1 << 5), /* 20 MHz channel okay */
/* Bit 6 Reserved (was Narrow Channel) */
EEPROM_CHANNEL_DFS = (1 << 7), /* dynamic freq selection candidate */
};
/* SKU Capabilities */
#define EEPROM_SKU_CAP_SW_RF_KILL_ENABLE (1 << 0)
#define EEPROM_SKU_CAP_HW_RF_KILL_ENABLE (1 << 1)
#define EEPROM_SKU_CAP_OP_MODE_MRC (1 << 7)
/* *regulatory* channel data from eeprom, one for each channel */
struct iwl3945_eeprom_channel {
u8 flags; /* flags copied from EEPROM */
s8 max_power_avg; /* max power (dBm) on this chnl, limit 31 */
} __attribute__ ((packed));
/*
* Mapping of a Tx power level, at factory calibration temperature,
* to a radio/DSP gain table index.
......@@ -227,7 +182,7 @@ struct iwl3945_eeprom {
* 2.4 GHz channels 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14
*/
u16 band_1_count; /* abs.ofs: 196 */
struct iwl3945_eeprom_channel band_1_channels[14]; /* abs.ofs: 196 */
struct iwl_eeprom_channel band_1_channels[14]; /* abs.ofs: 196 */
/*
* 4.9 GHz channels 183, 184, 185, 187, 188, 189, 192, 196,
......@@ -235,28 +190,28 @@ struct iwl3945_eeprom {
* (4915-5080MHz) (none of these is ever supported)
*/
u16 band_2_count; /* abs.ofs: 226 */
struct iwl3945_eeprom_channel band_2_channels[13]; /* abs.ofs: 228 */
struct iwl_eeprom_channel band_2_channels[13]; /* abs.ofs: 228 */
/*
* 5.2 GHz channels 34, 36, 38, 40, 42, 44, 46, 48, 52, 56, 60, 64
* (5170-5320MHz)
*/
u16 band_3_count; /* abs.ofs: 254 */
struct iwl3945_eeprom_channel band_3_channels[12]; /* abs.ofs: 256 */
struct iwl_eeprom_channel band_3_channels[12]; /* abs.ofs: 256 */
/*
* 5.5 GHz channels 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140
* (5500-5700MHz)
*/
u16 band_4_count; /* abs.ofs: 280 */
struct iwl3945_eeprom_channel band_4_channels[11]; /* abs.ofs: 282 */
struct iwl_eeprom_channel band_4_channels[11]; /* abs.ofs: 282 */
/*
* 5.7 GHz channels 145, 149, 153, 157, 161, 165
* (5725-5825MHz)
*/
u16 band_5_count; /* abs.ofs: 304 */
struct iwl3945_eeprom_channel band_5_channels[6]; /* abs.ofs: 306 */
struct iwl_eeprom_channel band_5_channels[6]; /* abs.ofs: 306 */
u8 reserved9[194];
......
......@@ -203,8 +203,8 @@ struct iwl3945_scan_power_info {
struct iwl3945_channel_info {
struct iwl3945_channel_tgd_info tgd;
struct iwl3945_channel_tgh_info tgh;
struct iwl3945_eeprom_channel eeprom; /* EEPROM regulatory limit */
struct iwl3945_eeprom_channel fat_eeprom; /* EEPROM regulatory limit for
struct iwl_eeprom_channel eeprom; /* EEPROM regulatory limit */
struct iwl_eeprom_channel fat_eeprom; /* EEPROM regulatory limit for
* FAT channel */
u8 channel; /* channel number */
......
......@@ -4483,7 +4483,7 @@ static const u8 iwl3945_eeprom_band_5[] = { /* 5725-5825MHz */
static void iwl3945_init_band_reference(const struct iwl3945_priv *priv, int band,
int *eeprom_ch_count,
const struct iwl3945_eeprom_channel
const struct iwl_eeprom_channel
**eeprom_ch_info,
const u8 **eeprom_ch_index)
{
......@@ -4558,7 +4558,7 @@ static int iwl3945_init_channel_map(struct iwl3945_priv *priv)
{
int eeprom_ch_count = 0;
const u8 *eeprom_ch_index = NULL;
const struct iwl3945_eeprom_channel *eeprom_ch_info = NULL;
const struct iwl_eeprom_channel *eeprom_ch_info = NULL;
int band, ch;
struct iwl3945_channel_info *ch_info;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment