Commit 14cb0deb authored by Baruch Siach's avatar Baruch Siach Committed by Sascha Hauer

arm/imx/gpio: add spinlock protection

The GPIO registers need protection from concurrent access for operations that
are not atomic.

Cc: stable@kernel.org
Cc: Juergen Beisert <j.beisert@pengutronix.de>
Cc: Daniel Mack <daniel@caiaq.de>
Reported-by: rpkamiak@rockwellcollins.com
Signed-off-by: default avatarBaruch Siach <baruch@tkos.co.il>
Signed-off-by: default avatarSascha Hauer <s.hauer@pengutronix.de>
parent ef93f144
......@@ -214,13 +214,16 @@ static void _set_gpio_direction(struct gpio_chip *chip, unsigned offset,
struct mxc_gpio_port *port =
container_of(chip, struct mxc_gpio_port, chip);
u32 l;
unsigned long flags;
spin_lock_irqsave(&port->lock, flags);
l = __raw_readl(port->base + GPIO_GDIR);
if (dir)
l |= 1 << offset;
else
l &= ~(1 << offset);
__raw_writel(l, port->base + GPIO_GDIR);
spin_unlock_irqrestore(&port->lock, flags);
}
static void mxc_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
......@@ -229,9 +232,12 @@ static void mxc_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
container_of(chip, struct mxc_gpio_port, chip);
void __iomem *reg = port->base + GPIO_DR;
u32 l;
unsigned long flags;
spin_lock_irqsave(&port->lock, flags);
l = (__raw_readl(reg) & (~(1 << offset))) | (value << offset);
__raw_writel(l, reg);
spin_unlock_irqrestore(&port->lock, flags);
}
static int mxc_gpio_get(struct gpio_chip *chip, unsigned offset)
......@@ -285,6 +291,8 @@ int __init mxc_gpio_init(struct mxc_gpio_port *port, int cnt)
port[i].chip.base = i * 32;
port[i].chip.ngpio = 32;
spin_lock_init(&port[i].lock);
/* its a serious configuration bug when it fails */
BUG_ON( gpiochip_add(&port[i].chip) < 0 );
......
......@@ -37,6 +37,7 @@ struct mxc_gpio_port {
int virtual_irq_start;
struct gpio_chip chip;
u32 both_edges;
spinlock_t lock;
};
int mxc_gpio_init(struct mxc_gpio_port*, int);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment