arm64: dts: qcom: sm6375: Add UART1

Add UART1 node, generally used for the Bluetooth module.
Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Link: https://lore.kernel.org/r/20230927-topic-6375_stuff-v1-1-12243e36b45c@linaro.orgSigned-off-by: Bjorn Andersson <andersson@kernel.org>

arch/arm64/boot/dts/qcom/sm6375.dtsi

@@ -896,6 +896,36 @@ qup_spi0_default: qup-spi0-default-state {
 				drive-strength = <6>;
 				bias-disable;
 			};
+
+			qup_uart1_default: qup-uart1-default-state {
+				cts-pins {
+					pins = "gpio61";
+					function = "qup01";
+					drive-strength = <2>;
+					bias-pull-down;
+				};
+
+				rts-pins {
+					pins = "gpio62";
+					function = "qup01";
+					drive-strength = <2>;
+					bias-disable;
+				};
+
+				tx-pins {
+					pins = "gpio63";
+					function = "qup01";
+					drive-strength = <2>;
+					bias-disable;
+				};
+
+				rx-pins {
+					pins = "gpio64";
+					function = "qup01";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+			};
 		};
 
 		gcc: clock-controller@1400000 {
@@ -1111,6 +1141,19 @@ spi1: spi@4a84000 {
 				status = "disabled";
 			};
 
+			uart1: serial@4a84000 {
+				compatible = "qcom,geni-uart";
+				reg = <0x0 0x04a84000 0x0 0x4000>;
+				interrupts = <GIC_SPI 328 IRQ_TYPE_LEVEL_HIGH>;
+				clocks = <&gcc GCC_QUPV3_WRAP0_S1_CLK>;
+				clock-names = "se";
+				power-domains = <&rpmpd SM6375_VDDCX>;
+				operating-points-v2 = <&qup_opp_table>;
+				pinctrl-0 = <&qup_uart1_default>;
+				pinctrl-names = "default";
+				status = "disabled";
+			};
+
 			i2c2: i2c@4a88000 {
 				compatible = "qcom,geni-i2c";
 				reg = <0x0 0x04a88000 0x0 0x4000>;