pinctrl/amd: fix gpio irq level in debugfs

According to the AMD BKDG, the GPIO ActiveLevel bits (10:9) map to:
 00 Active High
 01 Active Low
 10 Active on both edges iff LevelTrig (bit 8) == 0
 11 Reserved

The current code has a bug where it interprets 00 => Active Low, and
01 => Active High.

Fix the bug, restrict "Active on both" to just the edge trigger case, and
refactor a bit to make the logic more readable.
Signed-off-by: Daniel Kurtz <djkurtz@chromium.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/pinctrl-amd.c

@@ -247,16 +247,16 @@ static void amd_gpio_dbg_show(struct seq_file *s, struct gpio_chip *gc)
 			raw_spin_unlock_irqrestore(&gpio_dev->lock, flags);
 
 			if (pin_reg & BIT(INTERRUPT_ENABLE_OFF)) {
+				u8 level = (pin_reg >> ACTIVE_LEVEL_OFF) &
+						ACTIVE_LEVEL_MASK;
 				interrupt_enable = "interrupt is enabled|";
 
-				if (!(pin_reg & BIT(ACTIVE_LEVEL_OFF)) &&
-				    !(pin_reg & BIT(ACTIVE_LEVEL_OFF + 1)))
-					active_level = "Active low|";
-				else if (pin_reg & BIT(ACTIVE_LEVEL_OFF) &&
-					 !(pin_reg & BIT(ACTIVE_LEVEL_OFF + 1)))
+				if (level == ACTIVE_LEVEL_HIGH)
 					active_level = "Active high|";
-				else if (!(pin_reg & BIT(ACTIVE_LEVEL_OFF)) &&
-					 pin_reg & BIT(ACTIVE_LEVEL_OFF + 1))
+				else if (level == ACTIVE_LEVEL_LOW)
+					active_level = "Active low|";
+				else if (!(pin_reg & BIT(LEVEL_TRIG_OFF)) &&
+					 level == ACTIVE_LEVEL_BOTH)
 					active_level = "Active on both|";
 				else
 					active_level = "Unknown Active level|";

drivers/pinctrl/pinctrl-amd.h

@@ -54,6 +54,10 @@
 #define ACTIVE_LEVEL_MASK	0x3UL
 #define DRV_STRENGTH_SEL_MASK	0x3UL
 
+#define ACTIVE_LEVEL_HIGH	0x0UL
+#define ACTIVE_LEVEL_LOW	0x1UL
+#define ACTIVE_LEVEL_BOTH	0x2UL
+
 #define DB_TYPE_NO_DEBOUNCE               0x0UL
 #define DB_TYPE_PRESERVE_LOW_GLITCH       0x1UL
 #define DB_TYPE_PRESERVE_HIGH_GLITCH      0x2UL