Commit 180c14a6 authored by Peter Hurley's avatar Peter Hurley Committed by Greg Kroah-Hartman

serial: 8250_dw: Fix deadlock in LCR workaround

commit 7fd6f640 upstream.

Trying to write console output from within the serial console driver
while the port->lock is held causes recursive deadlock:

  CPU 0
spin_lock_irqsave(&port->lock)
printk()
  console_unlock()
    call_console_drivers()
      serial8250_console_write()
        spin_lock_irqsave(&port->lock)
** DEADLOCK **

The 8250_dw i/o accessors try to write a console error message if the
LCR workaround was unsuccessful. When the port->lock is already held
(eg., when called from serial8250_set_termios()), this deadlocks.

Make the error message a FIXME until a general solution is devised.

Cc: Tim Kryger <tim.kryger@gmail.com>
Reported-by: default avatarZhang Zhen <zhenzhang.zhang@huawei.com>
Signed-off-by: default avatarPeter Hurley <peter@hurleysoftware.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent f582a6d9
......@@ -111,7 +111,10 @@ static void dw8250_serial_out(struct uart_port *p, int offset, int value)
dw8250_force_idle(p);
writeb(value, p->membase + (UART_LCR << p->regshift));
}
dev_err(p->dev, "Couldn't set LCR to %d\n", value);
/*
* FIXME: this deadlocks if port->lock is already held
* dev_err(p->dev, "Couldn't set LCR to %d\n", value);
*/
}
}
......@@ -155,7 +158,10 @@ static void dw8250_serial_outq(struct uart_port *p, int offset, int value)
__raw_writeq(value & 0xff,
p->membase + (UART_LCR << p->regshift));
}
dev_err(p->dev, "Couldn't set LCR to %d\n", value);
/*
* FIXME: this deadlocks if port->lock is already held
* dev_err(p->dev, "Couldn't set LCR to %d\n", value);
*/
}
}
#endif /* CONFIG_64BIT */
......@@ -179,7 +185,10 @@ static void dw8250_serial_out32(struct uart_port *p, int offset, int value)
dw8250_force_idle(p);
writel(value, p->membase + (UART_LCR << p->regshift));
}
dev_err(p->dev, "Couldn't set LCR to %d\n", value);
/*
* FIXME: this deadlocks if port->lock is already held
* dev_err(p->dev, "Couldn't set LCR to %d\n", value);
*/
}
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment