Commit 1ef5b816 authored by Stefan Richter's avatar Stefan Richter

ieee1394: move init_ohci1394_dma to drivers/firewire/

because drivers/ieee1394/ will be deleted.

Additional changes:
  - add some #include directives
  - adjust to use firewire/ohci.h instead of ieee1394/ohci1394.h,
    replace struct ti_ohci by a minimal struct ohci,
    replace quadlet_t from ieee1394_types.h by u32
  - two or three trivial stylistic changes
  - __iomem annotation
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
parent cb655d0f
......@@ -13,3 +13,4 @@ obj-$(CONFIG_FIREWIRE_OHCI) += firewire-ohci.o
obj-$(CONFIG_FIREWIRE_SBP2) += firewire-sbp2.o
obj-$(CONFIG_FIREWIRE_NET) += firewire-net.o
obj-$(CONFIG_FIREWIRE_NOSY) += nosy.o
obj-$(CONFIG_PROVIDE_OHCI1394_DMA_INIT) += init_ohci1394_dma.o
......@@ -32,23 +32,41 @@
* Inc., 59 Temple Place - Suite 330, Boston, MA 02111-1307, USA.
*/
#include <linux/interrupt.h> /* for ohci1394.h */
#include <linux/delay.h>
#include <linux/io.h>
#include <linux/kernel.h>
#include <linux/pci.h> /* for PCI defines */
#include <linux/init_ohci1394_dma.h>
#include <linux/string.h>
#include <asm/pci-direct.h> /* for direct PCI config space access */
#include <asm/fixmap.h>
#include "ieee1394_types.h"
#include "ohci1394.h"
#include <linux/init_ohci1394_dma.h>
#include "ohci.h"
int __initdata init_ohci1394_dma_early;
struct ohci {
void __iomem *registers;
};
static inline void reg_write(const struct ohci *ohci, int offset, u32 data)
{
writel(data, ohci->registers + offset);
}
static inline u32 reg_read(const struct ohci *ohci, int offset)
{
return readl(ohci->registers + offset);
}
#define OHCI_LOOP_COUNT 100 /* Number of loops for reg read waits */
/* Reads a PHY register of an OHCI-1394 controller */
static inline u8 __init get_phy_reg(struct ti_ohci *ohci, u8 addr)
static inline u8 __init get_phy_reg(struct ohci *ohci, u8 addr)
{
int i;
quadlet_t r;
u32 r;
reg_write(ohci, OHCI1394_PhyControl, (addr << 8) | 0x00008000);
......@@ -63,22 +81,22 @@ static inline u8 __init get_phy_reg(struct ti_ohci *ohci, u8 addr)
}
/* Writes to a PHY register of an OHCI-1394 controller */
static inline void __init set_phy_reg(struct ti_ohci *ohci, u8 addr, u8 data)
static inline void __init set_phy_reg(struct ohci *ohci, u8 addr, u8 data)
{
int i;
reg_write(ohci, OHCI1394_PhyControl, (addr << 8) | data | 0x00004000);
for (i = 0; i < OHCI_LOOP_COUNT; i++) {
u32 r = reg_read(ohci, OHCI1394_PhyControl);
if (!(r & 0x00004000))
if (!(reg_read(ohci, OHCI1394_PhyControl) & 0x00004000))
break;
mdelay(1);
}
}
/* Resets an OHCI-1394 controller (for sane state before initialization) */
static inline void __init init_ohci1394_soft_reset(struct ti_ohci *ohci) {
static inline void __init init_ohci1394_soft_reset(struct ohci *ohci)
{
int i;
reg_write(ohci, OHCI1394_HCControlSet, OHCI1394_HCControl_softReset);
......@@ -91,10 +109,14 @@ static inline void __init init_ohci1394_soft_reset(struct ti_ohci *ohci) {
}
}
#define OHCI1394_MAX_AT_REQ_RETRIES 0xf
#define OHCI1394_MAX_AT_RESP_RETRIES 0x2
#define OHCI1394_MAX_PHYS_RESP_RETRIES 0x8
/* Basic OHCI-1394 register and port inititalization */
static inline void __init init_ohci1394_initialize(struct ti_ohci *ohci)
static inline void __init init_ohci1394_initialize(struct ohci *ohci)
{
quadlet_t bus_options;
u32 bus_options;
int num_ports, i;
/* Put some defaults to these undefined bus options */
......@@ -116,7 +138,7 @@ static inline void __init init_ohci1394_initialize(struct ti_ohci *ohci)
/* enable phys */
reg_write(ohci, OHCI1394_LinkControlSet,
OHCI1394_LinkControl_RcvPhyPkt);
OHCI1394_LinkControl_rcvPhyPkt);
/* Don't accept phy packets into AR request context */
reg_write(ohci, OHCI1394_LinkControlClear, 0x00000400);
......@@ -128,7 +150,7 @@ static inline void __init init_ohci1394_initialize(struct ti_ohci *ohci)
reg_write(ohci, OHCI1394_IsoXmitIntEventClear, 0xffffffff);
/* Accept asyncronous transfer requests from all nodes for now */
reg_write(ohci,OHCI1394_AsReqFilterHiSet, 0x80000000);
reg_write(ohci, OHCI1394_AsReqFilterHiSet, 0x80000000);
/* Specify asyncronous transfer retries */
reg_write(ohci, OHCI1394_ATRetries,
......@@ -137,7 +159,8 @@ static inline void __init init_ohci1394_initialize(struct ti_ohci *ohci)
(OHCI1394_MAX_PHYS_RESP_RETRIES<<8));
/* We don't want hardware swapping */
reg_write(ohci, OHCI1394_HCControlClear, OHCI1394_HCControl_noByteSwap);
reg_write(ohci, OHCI1394_HCControlClear,
OHCI1394_HCControl_noByteSwapData);
/* Enable link */
reg_write(ohci, OHCI1394_HCControlSet, OHCI1394_HCControl_linkEnable);
......@@ -164,11 +187,11 @@ static inline void __init init_ohci1394_initialize(struct ti_ohci *ohci)
* has to be enabled after each bus reset when needed. We resort
* to polling here because on early boot, we have no interrupts.
*/
static inline void __init init_ohci1394_wait_for_busresets(struct ti_ohci *ohci)
static inline void __init init_ohci1394_wait_for_busresets(struct ohci *ohci)
{
int i, events;
for (i=0; i < 9; i++) {
for (i = 0; i < 9; i++) {
mdelay(200);
events = reg_read(ohci, OHCI1394_IntEventSet);
if (events & OHCI1394_busReset)
......@@ -182,18 +205,18 @@ static inline void __init init_ohci1394_wait_for_busresets(struct ti_ohci *ohci)
* This enables remote DMA access over IEEE1394 from every host for the low
* 4GB of address space. DMA accesses above 4GB are not available currently.
*/
static inline void __init init_ohci1394_enable_physical_dma(struct ti_ohci *hci)
static inline void __init init_ohci1394_enable_physical_dma(struct ohci *ohci)
{
reg_write(hci, OHCI1394_PhyReqFilterHiSet, 0xffffffff);
reg_write(hci, OHCI1394_PhyReqFilterLoSet, 0xffffffff);
reg_write(hci, OHCI1394_PhyUpperBound, 0xffff0000);
reg_write(ohci, OHCI1394_PhyReqFilterHiSet, 0xffffffff);
reg_write(ohci, OHCI1394_PhyReqFilterLoSet, 0xffffffff);
reg_write(ohci, OHCI1394_PhyUpperBound, 0xffff0000);
}
/**
* init_ohci1394_reset_and_init_dma - init controller and enable DMA
* This initializes the given controller and enables physical DMA engine in it.
*/
static inline void __init init_ohci1394_reset_and_init_dma(struct ti_ohci *ohci)
static inline void __init init_ohci1394_reset_and_init_dma(struct ohci *ohci)
{
/* Start off with a soft reset, clears everything to a sane state. */
init_ohci1394_soft_reset(ohci);
......@@ -225,7 +248,7 @@ static inline void __init init_ohci1394_reset_and_init_dma(struct ti_ohci *ohci)
static inline void __init init_ohci1394_controller(int num, int slot, int func)
{
unsigned long ohci_base;
struct ti_ohci ohci;
struct ohci ohci;
printk(KERN_INFO "init_ohci1394_dma: initializing OHCI-1394"
" at %02x:%02x.%x\n", num, slot, func);
......@@ -235,7 +258,7 @@ static inline void __init init_ohci1394_controller(int num, int slot, int func)
set_fixmap_nocache(FIX_OHCI1394_BASE, ohci_base);
ohci.registers = (void *)fix_to_virt(FIX_OHCI1394_BASE);
ohci.registers = (void __iomem *)fix_to_virt(FIX_OHCI1394_BASE);
init_ohci1394_reset_and_init_dma(&ohci);
}
......@@ -247,6 +270,7 @@ static inline void __init init_ohci1394_controller(int num, int slot, int func)
void __init init_ohci1394_dma_on_all_controllers(void)
{
int num, slot, func;
u32 class;
if (!early_pci_allowed())
return;
......@@ -255,9 +279,9 @@ void __init init_ohci1394_dma_on_all_controllers(void)
for (num = 0; num < 32; num++) {
for (slot = 0; slot < 32; slot++) {
for (func = 0; func < 8; func++) {
u32 class = read_pci_config(num,slot,func,
class = read_pci_config(num, slot, func,
PCI_CLASS_REVISION);
if ((class == 0xffffffff))
if (class == 0xffffffff)
continue; /* No device at this func */
if (class>>8 != PCI_CLASS_SERIAL_FIREWIRE_OHCI)
......
......@@ -14,5 +14,3 @@ obj-$(CONFIG_IEEE1394_RAWIO) += raw1394.o
obj-$(CONFIG_IEEE1394_SBP2) += sbp2.o
obj-$(CONFIG_IEEE1394_DV1394) += dv1394.o
obj-$(CONFIG_IEEE1394_ETH1394) += eth1394.o
obj-$(CONFIG_PROVIDE_OHCI1394_DMA_INIT) += init_ohci1394_dma.o
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment