[ARM] 5323/1: Remove outdated empeg documentation.

The documents aren't particularly useful anyway and the hardware in
question has never run anything newer than a v2.2.14 kernel to my
knowledge.
Signed-off-by: Mike Crowe <mac@mcrowe.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Documentation/arm/empeg/README

-Empeg, Ltd's Empeg MP3 Car Audio Player
-
-The initial design is to go in your car, but you can use it at home, on a
-boat... almost anywhere. The principle is to store CD-quality music using
-MPEG technology onto a hard disk in the unit, and use the power of the
-embedded computer to serve up the music you want.
-
-For more details, see:
-
-	http://www.empeg.com
-
-
-

Documentation/arm/empeg/ir.txt

-Infra-red driver documentation.
-
-Mike Crowe <mac@empeg.com>
-(C) Empeg Ltd 1999
-
-Not a lot here yet :-)
-
-The Kenwood KCA-R6A remote control generates a sequence like the following:
-
-Go low for approx 16T (Around 9000us)
-Go high for approx 8T (Around 4000us)
-Go low for less than 2T (Around 750us)
-
-For each of the 32 bits
-  Go high for more than 2T (Around 1500us) == 1
-  Go high for less than T (Around 400us) == 0
-  Go low for less than 2T (Around 750us)
-
-Rather than repeat a signal when the button is held down certain buttons
-generate the following code to indicate repetition.
-
-Go low for approx 16T
-Go high for approx 4T
-Go low for less than 2T
-
-(By removing the <2T from the start of the sequence and placing at the end
- it can be considered a stop bit but I found it easier to deal with it at
- the start).
-
-The 32 bits are encoded as XxYy where x and y are the actual data values
-while X and Y are the logical inverses of the associated data values. Using 
-LSB first yields sensible codes for the numbers.
-
-All codes are of the form b9xx
-
-The numeric keys generate the code 0x where x is the number pressed.
-
-Tuner		1c
-Tape		1d
-CD		1e
-CD-MD-CH	1f
-Track-		0a
-Track+		0b
-Rewind		0c
-FF		0d
-DNPP		5e
-Play/Pause	0e
-Vol+		14
-Vol-		15

Documentation/arm/empeg/mkdevs

-#!/bin/sh
-mknod /dev/display c 244 0
-mknod /dev/ir c 242 0
-mknod /dev/usb0 c 243 0
-mknod /dev/audio c 245 4
-mknod /dev/dsp c 245 3
-mknod /dev/mixer c 245 0
-mknod /dev/empeg_state c 246 0
-mknod /dev/radio0 c 81 64
-ln -sf radio0 radio
-ln -sf usb0 usb