xhci-pci: Only run d3cold avoidance quirk for s2idle

Donghun reports that a notebook that has an AMD Ryzen 5700U but supports
S3 has problems with USB after resuming from suspend. The issue was
bisected down to commit d1658268 ("usb: pci-quirks: disable D3cold on
xhci suspend for s2idle on AMD Renoir").

As this issue only happens on S3, narrow the broken D3cold quirk to only
run in s2idle.

Fixes: d1658268 ("usb: pci-quirks: disable D3cold on xhci suspend for s2idle on AMD Renoir")
Reported-and-tested-by: Donghun Yoon <donghun.yoon@lge.com>
Cc: stable@vger.kernel.org
Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Link: https://lore.kernel.org/r/20230515134059.161110-2-mathias.nyman@linux.intel.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/xhci-pci.c

@@ -13,6 +13,7 @@
 #include <linux/module.h>
 #include <linux/acpi.h>
 #include <linux/reset.h>
+#include <linux/suspend.h>
 
 #include "xhci.h"
 #include "xhci-trace.h"
@@ -387,7 +388,7 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
 
 	if (pdev->vendor == PCI_VENDOR_ID_AMD &&
 		pdev->device == PCI_DEVICE_ID_AMD_RENOIR_XHCI)
-		xhci->quirks |= XHCI_BROKEN_D3COLD;
+		xhci->quirks |= XHCI_BROKEN_D3COLD_S2I;
 
 	if (pdev->vendor == PCI_VENDOR_ID_INTEL) {
 		xhci->quirks |= XHCI_LPM_SUPPORT;
@@ -801,9 +802,16 @@ static int xhci_pci_suspend(struct usb_hcd *hcd, bool do_wakeup)
 	 * Systems with the TI redriver that loses port status change events
 	 * need to have the registers polled during D3, so avoid D3cold.
 	 */
-	if (xhci->quirks & (XHCI_COMP_MODE_QUIRK | XHCI_BROKEN_D3COLD))
+	if (xhci->quirks & XHCI_COMP_MODE_QUIRK)
 		pci_d3cold_disable(pdev);
 
+#ifdef CONFIG_SUSPEND
+	/* d3cold is broken, but only when s2idle is used */
+	if (pm_suspend_target_state == PM_SUSPEND_TO_IDLE &&
+	    xhci->quirks & (XHCI_BROKEN_D3COLD_S2I))
+		pci_d3cold_disable(pdev);
+#endif
+
 	if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
 		xhci_pme_quirk(hcd);
 

drivers/usb/host/xhci.h

@@ -1901,7 +1901,7 @@ struct xhci_hcd {
 #define XHCI_DISABLE_SPARSE	BIT_ULL(38)
 #define XHCI_SG_TRB_CACHE_SIZE_QUIRK	BIT_ULL(39)
 #define XHCI_NO_SOFT_RETRY	BIT_ULL(40)
-#define XHCI_BROKEN_D3COLD	BIT_ULL(41)
+#define XHCI_BROKEN_D3COLD_S2I	BIT_ULL(41)
 #define XHCI_EP_CTX_BROKEN_DCS	BIT_ULL(42)
 #define XHCI_SUSPEND_RESUME_CLKS	BIT_ULL(43)
 #define XHCI_RESET_TO_DEFAULT	BIT_ULL(44)