e1000e: initial support for i217

i217 is the next-generation LOM that will be available on systems with the
Lynx Point Platform Controller Hub (PCH) chipset from Intel.  This patch
provides the initial support for the device.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/e1000e/defines.h

@@ -74,7 +74,9 @@
 #define E1000_WUS_BC           E1000_WUFC_BC
 
 /* Extended Device Control */
+#define E1000_CTRL_EXT_LPCD  0x00000004     /* LCD Power Cycle Done */
 #define E1000_CTRL_EXT_SDP3_DATA 0x00000080 /* Value of SW Definable Pin 3 */
+#define E1000_CTRL_EXT_FORCE_SMBUS 0x00000004 /* Force SMBus mode*/
 #define E1000_CTRL_EXT_EE_RST    0x00002000 /* Reinitialize from EEPROM */
 #define E1000_CTRL_EXT_SPD_BYPS  0x00008000 /* Speed Select Bypass */
 #define E1000_CTRL_EXT_RO_DIS    0x00020000 /* Relaxed Ordering disable */
@@ -573,6 +575,7 @@
 #define NWAY_AR_ASM_DIR          0x0800   /* Asymmetric Pause Direction bit */
 
 /* Link Partner Ability Register (Base Page) */
+#define NWAY_LPAR_100TX_FD_CAPS  0x0100 /* LP 100TX Full Dplx Capable */
 #define NWAY_LPAR_PAUSE          0x0400 /* LP Pause operation desired */
 #define NWAY_LPAR_ASM_DIR        0x0800 /* LP Asymmetric Pause Direction bit */
 
@@ -739,6 +742,7 @@
 #define I82577_E_PHY_ID      0x01540050
 #define I82578_E_PHY_ID      0x004DD040
 #define I82579_E_PHY_ID      0x01540090
+#define I217_E_PHY_ID        0x015400A0
 
 /* M88E1000 Specific Registers */
 #define M88E1000_PHY_SPEC_CTRL     0x10  /* PHY Specific Control Register */
@@ -850,4 +854,8 @@
 /* SerDes Control */
 #define E1000_GEN_POLL_TIMEOUT          640
 
+/* FW Semaphore */
+#define E1000_FWSM_WLOCK_MAC_MASK	0x0380
+#define E1000_FWSM_WLOCK_MAC_SHIFT	7
+
 #endif /* _E1000_DEFINES_H_ */

drivers/net/ethernet/intel/e1000e/e1000.h

@@ -206,6 +206,7 @@ enum e1000_boards {
 	board_ich10lan,
 	board_pchlan,
 	board_pch2lan,
+	board_pch_lpt,
 };
 
 struct e1000_ps_page {
@@ -528,6 +529,7 @@ extern const struct e1000_info e1000_ich9_info;
 extern const struct e1000_info e1000_ich10_info;
 extern const struct e1000_info e1000_pch_info;
 extern const struct e1000_info e1000_pch2_info;
+extern const struct e1000_info e1000_pch_lpt_info;
 extern const struct e1000_info e1000_es2_info;
 
 extern s32 e1000_read_pba_string_generic(struct e1000_hw *hw, u8 *pba_num,

drivers/net/ethernet/intel/e1000e/ethtool.c

@@ -773,6 +773,7 @@ static int e1000_reg_test(struct e1000_adapter *adapter, u64 *data)
 	u32 i;
 	u32 toggle;
 	u32 mask;
+	u32 wlock_mac = 0;
 
 	/*
 	 * The status register is Read Only, so a write should fail.
@@ -838,19 +839,31 @@ static int e1000_reg_test(struct e1000_adapter *adapter, u64 *data)
 	case e1000_ich10lan:
 	case e1000_pchlan:
 	case e1000_pch2lan:
+	case e1000_pch_lpt:
 		mask |= (1 << 18);
 		break;
 	default:
 		break;
 	}
-	for (i = 0; i < mac->rar_entry_count; i++)
+
+	if (mac->type == e1000_pch_lpt)
+		wlock_mac = (er32(FWSM) & E1000_FWSM_WLOCK_MAC_MASK) >>
+		    E1000_FWSM_WLOCK_MAC_SHIFT;
+
+	for (i = 0; i < mac->rar_entry_count; i++) {
+		/* Cannot test write-protected SHRAL[n] registers */
+		if ((wlock_mac == 1) || (wlock_mac && (i > wlock_mac)))
+			continue;
+
 		REG_PATTERN_TEST_ARRAY(E1000_RA, ((i << 1) + 1),
 				       mask, 0xFFFFFFFF);
+	}
 
 	for (i = 0; i < mac->mta_reg_count; i++)
 		REG_PATTERN_TEST_ARRAY(E1000_MTA, i, 0xFFFFFFFF, 0xFFFFFFFF);
 
 	*data = 0;
+
 	return 0;
 }
 

drivers/net/ethernet/intel/e1000e/hw.h

@@ -200,6 +200,10 @@ enum e1e_registers {
 #define E1000_RA        (E1000_RAL(0))
 	E1000_RAH_BASE = 0x05404, /* Receive Address High - RW */
 #define E1000_RAH(_n)   (E1000_RAH_BASE + ((_n) * 8))
+	E1000_SHRAL_PCH_LPT_BASE = 0x05408,
+#define E1000_SHRAL_PCH_LPT(_n)   (E1000_SHRAL_PCH_LPT_BASE + ((_n) * 8))
+	E1000_SHRAH_PCH_LTP_BASE = 0x0540C,
+#define E1000_SHRAH_PCH_LPT(_n)   (E1000_SHRAH_PCH_LTP_BASE + ((_n) * 8))
 	E1000_SHRAL_BASE = 0x05438, /* Shared Receive Address Low - RW */
 #define E1000_SHRAL(_n)   (E1000_SHRAL_BASE + ((_n) * 8))
 	E1000_SHRAH_BASE = 0x0543C, /* Shared Receive Address High - RW */
@@ -406,6 +410,8 @@ enum e1e_registers {
 #define E1000_DEV_ID_PCH_D_HV_DC		0x10F0
 #define E1000_DEV_ID_PCH2_LV_LM			0x1502
 #define E1000_DEV_ID_PCH2_LV_V			0x1503
+#define E1000_DEV_ID_PCH_LPT_I217_LM		0x153A
+#define E1000_DEV_ID_PCH_LPT_I217_V		0x153B
 
 #define E1000_REVISION_4 4
 
@@ -426,6 +432,7 @@ enum e1000_mac_type {
 	e1000_ich10lan,
 	e1000_pchlan,
 	e1000_pch2lan,
+	e1000_pch_lpt,
 };
 
 enum e1000_media_type {
@@ -463,6 +470,7 @@ enum e1000_phy_type {
 	e1000_phy_82578,
 	e1000_phy_82577,
 	e1000_phy_82579,
+	e1000_phy_i217,
 };
 
 enum e1000_bus_width {
@@ -971,6 +979,7 @@ struct e1000_dev_spec_ich8lan {
 	struct e1000_shadow_ram shadow_ram[E1000_ICH8_SHADOW_RAM_WORDS];
 	bool nvm_k1_enabled;
 	bool eee_disable;
+	u16 eee_lp_ability;
 };
 
 struct e1000_hw {

drivers/net/ethernet/intel/e1000e/netdev.c

@@ -79,6 +79,7 @@ static const struct e1000_info *e1000_info_tbl[] = {
 	[board_ich10lan]	= &e1000_ich10_info,
 	[board_pchlan]		= &e1000_pch_info,
 	[board_pch2lan]		= &e1000_pch2_info,
+	[board_pch_lpt]		= &e1000_pch_lpt_info,
 };
 
 struct e1000_reg_info {
@@ -2863,8 +2864,8 @@ static void e1000_setup_rctl(struct e1000_adapter *adapter)
 	u32 rctl, rfctl;
 	u32 pages = 0;
 
-	/* Workaround Si errata on 82579 - configure jumbo frame flow */
-	if (hw->mac.type == e1000_pch2lan) {
+	/* Workaround Si errata on PCHx - configure jumbo frame flow */
+	if (hw->mac.type >= e1000_pch2lan) {
 		s32 ret_val;
 
 		if (adapter->netdev->mtu > ETH_DATA_LEN)
@@ -3487,6 +3488,7 @@ void e1000e_reset(struct e1000_adapter *adapter)
 		fc->refresh_time = 0x1000;
 		break;
 	case e1000_pch2lan:
+	case e1000_pch_lpt:
 		fc->high_water = 0x05C20;
 		fc->low_water = 0x05048;
 		fc->pause_time = 0x0650;
@@ -5264,11 +5266,11 @@ static int e1000_change_mtu(struct net_device *netdev, int new_mtu)
 		return -EINVAL;
 	}
 
-	/* Jumbo frame workaround on 82579 requires CRC be stripped */
-	if ((adapter->hw.mac.type == e1000_pch2lan) &&
+	/* Jumbo frame workaround on 82579 and newer requires CRC be stripped */
+	if ((adapter->hw.mac.type >= e1000_pch2lan) &&
 	    !(adapter->flags2 & FLAG2_CRC_STRIPPING) &&
 	    (new_mtu > ETH_DATA_LEN)) {
-		e_err("Jumbo Frames not supported on 82579 when CRC stripping is disabled.\n");
+		e_err("Jumbo Frames not supported on this device when CRC stripping is disabled.\n");
 		return -EINVAL;
 	}
 
@@ -5665,7 +5667,7 @@ static int __e1000_resume(struct pci_dev *pdev)
 			return err;
 	}
 
-	if (hw->mac.type == e1000_pch2lan)
+	if (hw->mac.type >= e1000_pch2lan)
 		e1000_resume_workarounds_pchlan(&adapter->hw);
 
 	e1000e_power_up_phy(adapter);
@@ -6564,6 +6566,9 @@ static DEFINE_PCI_DEVICE_TABLE(e1000_pci_tbl) = {
 	{ PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH2_LV_LM), board_pch2lan },
 	{ PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH2_LV_V), board_pch2lan },
 
+	{ PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_LPT_I217_LM), board_pch_lpt },
+	{ PCI_VDEVICE(INTEL, E1000_DEV_ID_PCH_LPT_I217_V), board_pch_lpt },
+
 	{ 0, 0, 0, 0, 0, 0, 0 }	/* terminate list */
 };
 MODULE_DEVICE_TABLE(pci, e1000_pci_tbl);

drivers/net/ethernet/intel/e1000e/phy.c

@@ -2335,6 +2335,9 @@ enum e1000_phy_type e1000e_get_phy_type_from_id(u32 phy_id)
 	case I82579_E_PHY_ID:
 		phy_type = e1000_phy_82579;
 		break;
+	case I217_E_PHY_ID:
+		phy_type = e1000_phy_i217;
+		break;
 	default:
 		phy_type = e1000_phy_unknown;
 		break;