Commit 36894e8b authored by Tvrtko Ursulin's avatar Tvrtko Ursulin

drm/i915/guc: Do not wait for firmware load atomically

It does not look like this code needs to wait atomically?

Higher in the call chain it calls the GEM API and I do
not see that the section is under any spin locks or such.
Signed-off-by: default avatarTvrtko Ursulin <tvrtko.ursulin@intel.com>
Cc: Alex Dai <yu.dai@intel.com>
Reviewed-by: default avatarDave Gordon <david.s.gordon@intel.com>
parent ee504898
......@@ -199,7 +199,7 @@ static void set_guc_init_params(struct drm_i915_private *dev_priv)
* the value matches either of two values representing completion
* of the GuC boot process.
*
* This is used for polling the GuC status in a wait_for_atomic()
* This is used for polling the GuC status in a wait_for()
* loop below.
*/
static inline bool guc_ucode_response(struct drm_i915_private *dev_priv,
......@@ -259,14 +259,14 @@ static int guc_ucode_xfer_dma(struct drm_i915_private *dev_priv)
I915_WRITE(DMA_CTRL, _MASKED_BIT_ENABLE(UOS_MOVE | START_DMA));
/*
* Spin-wait for the DMA to complete & the GuC to start up.
* Wait for the DMA to complete & the GuC to start up.
* NB: Docs recommend not using the interrupt for completion.
* Measurements indicate this should take no more than 20ms, so a
* timeout here indicates that the GuC has failed and is unusable.
* (Higher levels of the driver will attempt to fall back to
* execlist mode if this happens.)
*/
ret = wait_for_atomic(guc_ucode_response(dev_priv, &status), 100);
ret = wait_for(guc_ucode_response(dev_priv, &status), 100);
DRM_DEBUG_DRIVER("DMA status 0x%x, GuC status 0x%x\n",
I915_READ(DMA_CTRL), status);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment