ARM: dts: sunxi: Add CEC clock to DW-HDMI

Experimentation determined that HDMI CEC controller inside DW HDMI block
depends on 32k clock from RTC. If this clock is tampered with, HDMI CEC
communication starts or stops working, depending on situation.

SoC user manual doesn't say anything about CEC, so this was overlooked.
Fix this by adding dependency to RTC 32k clock.
Signed-off-by: Jernej Skrabec <jernej.skrabec@gmail.com>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://lore.kernel.org/r/20211120073448.32480-3-jernej.skrabec@gmail.com

arch/arm/boot/dts/sun8i-r40.dtsi

@@ -1212,8 +1212,8 @@ hdmi: hdmi@1ee0000 {
 			reg-io-width = <1>;
 			interrupts = <GIC_SPI 58 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_HDMI0>, <&ccu CLK_HDMI_SLOW>,
-				 <&ccu CLK_HDMI>;
-			clock-names = "iahb", "isfr", "tmds";
+				 <&ccu CLK_HDMI>, <&rtc 0>;
+			clock-names = "iahb", "isfr", "tmds", "cec";
 			resets = <&ccu RST_BUS_HDMI1>;
 			reset-names = "ctrl";
 			phys = <&hdmi_phy>;

arch/arm/boot/dts/sunxi-h3-h5.dtsi

@@ -813,8 +813,8 @@ hdmi: hdmi@1ee0000 {
 			reg-io-width = <1>;
 			interrupts = <GIC_SPI 88 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_HDMI>, <&ccu CLK_HDMI_DDC>,
-				 <&ccu CLK_HDMI>;
-			clock-names = "iahb", "isfr", "tmds";
+				 <&ccu CLK_HDMI>, <&rtc 0>;
+			clock-names = "iahb", "isfr", "tmds", "cec";
 			resets = <&ccu RST_BUS_HDMI1>;
 			reset-names = "ctrl";
 			phys = <&hdmi_phy>;