Commit 3b81221a authored by Huang Rui's avatar Huang Rui Committed by Felipe Balbi

usb: dwc3: add disscramble quirk

This patch adds disscramble quirk, and it only needs to be enabled at fpga
board on some vendor platforms.
Signed-off-by: default avatarHuang Rui <ray.huang@amd.com>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent 8f317b47
......@@ -14,6 +14,8 @@ Optional properties:
- phys: from the *Generic PHY* bindings
- phy-names: from the *Generic PHY* bindings
- tx-fifo-resize: determines if the FIFO *has* to be reallocated.
- snps,disable_scramble_quirk: true when SW should disable data scrambling.
Only really useful for FPGA builds.
This is usually a subnode to DWC3 glue to which it is connected.
......
......@@ -422,7 +422,6 @@ static int dwc3_core_init(struct dwc3 *dwc)
reg = dwc3_readl(dwc->regs, DWC3_GCTL);
reg &= ~DWC3_GCTL_SCALEDOWN_MASK;
reg &= ~DWC3_GCTL_DISSCRAMBLE;
switch (DWC3_GHWPARAMS1_EN_PWROPT(dwc->hwparams.hwparams1)) {
case DWC3_GHWPARAMS1_EN_PWROPT_CLK:
......@@ -466,6 +465,14 @@ static int dwc3_core_init(struct dwc3 *dwc)
dwc->is_fpga = true;
}
WARN_ONCE(dwc->disable_scramble_quirk && !dwc->is_fpga,
"disable_scramble cannot be used on non-FPGA builds\n");
if (dwc->disable_scramble_quirk && dwc->is_fpga)
reg |= DWC3_GCTL_DISSCRAMBLE;
else
reg &= ~DWC3_GCTL_DISSCRAMBLE;
/*
* WORKAROUND: DWC3 revisions <1.90a have a bug
* where the device can fail to connect at SuperSpeed
......@@ -710,11 +717,16 @@ static int dwc3_probe(struct platform_device *pdev)
dwc->needs_fifo_resize = of_property_read_bool(node, "tx-fifo-resize");
dwc->dr_mode = of_usb_get_dr_mode(node);
dwc->disable_scramble_quirk = of_property_read_bool(node,
"snps,disable_scramble_quirk");
} else if (pdata) {
dwc->maximum_speed = pdata->maximum_speed;
dwc->needs_fifo_resize = pdata->tx_fifo_resize;
dwc->dr_mode = pdata->dr_mode;
dwc->disable_scramble_quirk = pdata->disable_scramble_quirk;
}
/* default to superspeed if no maximum_speed passed */
......
......@@ -672,6 +672,7 @@ struct dwc3_scratchpad_array {
* @setup_packet_pending: true when there's a Setup Packet in FIFO. Workaround
* @start_config_issued: true when StartConfig command has been issued
* @three_stage_setup: set if we perform a three phase setup
* @disable_scramble_quirk: set if we enable the disable scramble quirk
*/
struct dwc3 {
struct usb_ctrlrequest *ctrl_req;
......@@ -776,6 +777,8 @@ struct dwc3 {
unsigned setup_packet_pending:1;
unsigned start_config_issued:1;
unsigned three_stage_setup:1;
unsigned disable_scramble_quirk:1;
};
/* -------------------------------------------------------------------------- */
......
......@@ -24,4 +24,6 @@ struct dwc3_platform_data {
enum usb_device_speed maximum_speed;
enum usb_dr_mode dr_mode;
bool tx_fifo_resize;
unsigned disable_scramble_quirk:1;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment