rtc: ds1307: comment and format cleanup

Do some cleanup of the comment sections as well as correct some
formatting issues reported by checkpatch.pl.
Signed-off-by: David Anders <x0132446@ti.com>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Austin Boyle <Austin.Boyle@aviatnet.com>
Cc: Alessandro Zummo <alessandro.zummo@towertech.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/rtc/rtc-ds1307.c

@@ -20,7 +20,8 @@
 
 
 
-/* We can't determine type by probing, but if we expect pre-Linux code
+/*
+ * We can't determine type by probing, but if we expect pre-Linux code
  * to have set the chip up as a clock (turning on the oscillator and
  * setting the date and time), Linux can ignore the non-clock features.
  * That's a natural job for a factory or repair bench.
@@ -37,7 +38,7 @@ enum ds_type {
 	mcp7941x,
 	rx_8025,
 	last_ds_type /* always last */
-	// rs5c372 too?  different address...
+	/* rs5c372 too?  different address... */
 };
 
 
@@ -59,7 +60,8 @@ enum ds_type {
 #	define DS1337_BIT_CENTURY	0x80	/* in REG_MONTH */
 #define DS1307_REG_YEAR		0x06	/* 00-99 */
 
-/* Other registers (control, status, alarms, trickle charge, NVRAM, etc)
+/*
+ * Other registers (control, status, alarms, trickle charge, NVRAM, etc)
  * start at 7, and they differ a LOT. Only control and status matter for
  * basic RTC date and time functionality; be careful using them.
  */
@@ -366,6 +368,11 @@ static int ds1307_set_time(struct device *dev, struct rtc_time *t)
 				| DS1340_BIT_CENTURY;
 		break;
 	case mcp7941x:
+		/*
+		 * these bits were cleared when preparing the date/time
+		 * values and need to be set again before writing the
+		 * buffer out to the device.
+		 */
 		buf[DS1307_REG_SECS] |= MCP7941X_BIT_ST;
 		buf[DS1307_REG_WDAY] |= MCP7941X_BIT_VBATEN;
 		break;
@@ -411,7 +418,8 @@ static int ds1337_read_alarm(struct device *dev, struct rtc_wkalrm *t)
 			ds1307->regs[6], ds1307->regs[7],
 			ds1307->regs[8]);
 
-	/* report alarm time (ALARM1); assume 24 hour and day-of-month modes,
+	/*
+	 * report alarm time (ALARM1); assume 24 hour and day-of-month modes,
 	 * and that all four fields are checked matches
 	 */
 	t->time.tm_sec = bcd2bin(ds1307->regs[0] & 0x7f);
@@ -602,8 +610,6 @@ static struct bin_attribute nvram = {
 
 /*----------------------------------------------------------------------*/
 
-static struct i2c_driver ds1307_driver;
-
 static int __devinit ds1307_probe(struct i2c_client *client,
 				  const struct i2c_device_id *id)
 {
@@ -624,7 +630,8 @@ static int __devinit ds1307_probe(struct i2c_client *client,
 	    && !i2c_check_functionality(adapter, I2C_FUNC_SMBUS_I2C_BLOCK))
 		return -EIO;
 
-	if (!(ds1307 = kzalloc(sizeof(struct ds1307), GFP_KERNEL)))
+	ds1307 = kzalloc(sizeof(struct ds1307), GFP_KERNEL);
+	if (!ds1307)
 		return -ENOMEM;
 
 	i2c_set_clientdata(client, ds1307);
@@ -659,7 +666,8 @@ static int __devinit ds1307_probe(struct i2c_client *client,
 		if (ds1307->regs[0] & DS1337_BIT_nEOSC)
 			ds1307->regs[0] &= ~DS1337_BIT_nEOSC;
 
-		/* Using IRQ?  Disable the square wave and both alarms.
+		/*
+		 * Using IRQ?  Disable the square wave and both alarms.
 		 * For some variants, be sure alarms can trigger when we're
 		 * running on Vbackup (BBSQI/BBSQW)
 		 */
@@ -765,7 +773,8 @@ static int __devinit ds1307_probe(struct i2c_client *client,
 		goto exit_free;
 	}
 
-	/* minimal sanity checking; some chips (like DS1340) don't
+	/*
+	 * minimal sanity checking; some chips (like DS1340) don't
 	 * specify the extra bits as must-be-zero, but there are
 	 * still a few values that are clearly out-of-range.
 	 */
@@ -837,7 +846,8 @@ static int __devinit ds1307_probe(struct i2c_client *client,
 	switch (ds1307->type) {
 	case ds_1340:
 	case m41t00:
-		/* NOTE: ignores century bits; fix before deploying
+		/*
+		 * NOTE: ignores century bits; fix before deploying
 		 * systems that will run through year 2100.
 		 */
 		break;
@@ -847,7 +857,8 @@ static int __devinit ds1307_probe(struct i2c_client *client,
 		if (!(tmp & DS1307_BIT_12HR))
 			break;
 
-		/* Be sure we're in 24 hour mode.  Multi-master systems
+		/*
+		 * Be sure we're in 24 hour mode.  Multi-master systems
 		 * take note...
 		 */
 		tmp = bcd2bin(tmp & 0x1f);