usb: dwc2: Use generic PHY width in params setup

Setting params.phy_utmi_width in dwc2_lowlevel_hw_init() is pointless since
it's value will be overwritten by dwc2_init_params().

This change make sure to take in account the generic PHY width information
during paraminitialisation, done in dwc2_set_param_phy_utmi_width().

By doing so, the phy_utmi_width params can still be overrided by
devicetree specific params and will also be checked against hardware
capabilities.

Fixes: 707d80f0 ("usb: dwc2: gadget: Replace phyif with phy_utmi_width")
Acked-by: Minas Harutyunyan <hminas@synopsys.com>
Tested-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Jules Maselbas <jmaselbas@kalray.eu>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>

drivers/usb/dwc2/params.c

@@ -253,6 +253,15 @@ static void dwc2_set_param_phy_utmi_width(struct dwc2_hsotg *hsotg)
 	val = (hsotg->hw_params.utmi_phy_data_width ==
 	       GHWCFG4_UTMI_PHY_DATA_WIDTH_8) ? 8 : 16;
 
+	if (hsotg->phy) {
+		/*
+		 * If using the generic PHY framework, check if the PHY bus
+		 * width is 8-bit and set the phyif appropriately.
+		 */
+		if (phy_get_bus_width(hsotg->phy) == 8)
+			val = 8;
+	}
+
 	hsotg->params.phy_utmi_width = val;
 }
 

drivers/usb/dwc2/platform.c

@@ -271,15 +271,6 @@ static int dwc2_lowlevel_hw_init(struct dwc2_hsotg *hsotg)
 
 	hsotg->plat = dev_get_platdata(hsotg->dev);
 
-	if (hsotg->phy) {
-		/*
-		 * If using the generic PHY framework, check if the PHY bus
-		 * width is 8-bit and set the phyif appropriately.
-		 */
-		if (phy_get_bus_width(hsotg->phy) == 8)
-			hsotg->params.phy_utmi_width = 8;
-	}
-
 	/* Clock */
 	hsotg->clk = devm_clk_get_optional(hsotg->dev, "otg");
 	if (IS_ERR(hsotg->clk)) {