Commit 523d9cfb authored by Mark Brown's avatar Mark Brown

mfd: Support software initiated shutdown of WM831x PMICs

In systems where there is no hardware signal from the processor to the
PMIC to initiate the final power off sequence we must initiate the
shutdown with a register write to the PMIC. Support such systems in the
driver. Since this may prevent a full shutdown of the system platform
data is used to enable the feature.
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: default avatarSamuel Ortiz <sameo@linux.intel.com>
parent 92afb286
......@@ -25,6 +25,7 @@
#include <linux/mfd/wm831x/irq.h>
#include <linux/mfd/wm831x/auxadc.h>
#include <linux/mfd/wm831x/otp.h>
#include <linux/mfd/wm831x/pmu.h>
#include <linux/mfd/wm831x/regulator.h>
/* Current settings - values are 2*2^(reg_val/4) microamps. These are
......@@ -1621,6 +1622,7 @@ int wm831x_device_init(struct wm831x *wm831x, unsigned long id, int irq)
mutex_init(&wm831x->io_lock);
mutex_init(&wm831x->key_lock);
dev_set_drvdata(wm831x->dev, wm831x);
wm831x->soft_shutdown = pdata->soft_shutdown;
ret = wm831x_reg_read(wm831x, WM831X_PARENT_ID);
if (ret < 0) {
......@@ -1922,6 +1924,15 @@ int wm831x_device_suspend(struct wm831x *wm831x)
return 0;
}
void wm831x_device_shutdown(struct wm831x *wm831x)
{
if (wm831x->soft_shutdown) {
dev_info(wm831x->dev, "Initiating shutdown...\n");
wm831x_set_bits(wm831x, WM831X_POWER_STATE, WM831X_CHIP_ON, 0);
}
}
EXPORT_SYMBOL_GPL(wm831x_device_shutdown);
MODULE_DESCRIPTION("Core support for the WM831X AudioPlus PMIC");
MODULE_LICENSE("GPL");
MODULE_AUTHOR("Mark Brown");
......@@ -65,6 +65,13 @@ static int wm831x_i2c_suspend(struct device *dev)
return wm831x_device_suspend(wm831x);
}
static void wm831x_i2c_shutdown(struct i2c_client *i2c)
{
struct wm831x *wm831x = i2c_get_clientdata(i2c);
wm831x_device_shutdown(wm831x);
}
static const struct i2c_device_id wm831x_i2c_id[] = {
{ "wm8310", WM8310 },
{ "wm8311", WM8311 },
......@@ -89,6 +96,7 @@ static struct i2c_driver wm831x_i2c_driver = {
},
.probe = wm831x_i2c_probe,
.remove = wm831x_i2c_remove,
.shutdown = wm831x_i2c_shutdown,
.id_table = wm831x_i2c_id,
};
......
......@@ -68,6 +68,13 @@ static int wm831x_spi_suspend(struct device *dev)
return wm831x_device_suspend(wm831x);
}
static void wm831x_spi_shutdown(struct spi_device *spi)
{
struct wm831x *wm831x = dev_get_drvdata(&spi->dev);
wm831x_device_shutdown(wm831x);
}
static const struct dev_pm_ops wm831x_spi_pm = {
.freeze = wm831x_spi_suspend,
.suspend = wm831x_spi_suspend,
......@@ -95,6 +102,7 @@ static struct spi_driver wm831x_spi_driver = {
.id_table = wm831x_spi_ids,
.probe = wm831x_spi_probe,
.remove = __devexit_p(wm831x_spi_remove),
.shutdown = wm831x_spi_shutdown,
};
static int __init wm831x_spi_init(void)
......
......@@ -371,6 +371,8 @@ struct wm831x {
int irq_masks_cur[WM831X_NUM_IRQ_REGS]; /* Currently active value */
int irq_masks_cache[WM831X_NUM_IRQ_REGS]; /* Cached hardware value */
bool soft_shutdown;
/* Chip revision based flags */
unsigned has_gpio_ena:1; /* Has GPIO enable bit */
unsigned has_cs_sts:1; /* Has current sink status bit */
......@@ -409,6 +411,7 @@ int wm831x_bulk_read(struct wm831x *wm831x, unsigned short reg,
int wm831x_device_init(struct wm831x *wm831x, unsigned long id, int irq);
void wm831x_device_exit(struct wm831x *wm831x);
int wm831x_device_suspend(struct wm831x *wm831x);
void wm831x_device_shutdown(struct wm831x *wm831x);
int wm831x_irq_init(struct wm831x *wm831x, int irq);
void wm831x_irq_exit(struct wm831x *wm831x);
void wm831x_auxadc_init(struct wm831x *wm831x);
......
......@@ -123,6 +123,9 @@ struct wm831x_pdata {
/** Disable the touchscreen */
bool disable_touch;
/** The driver should initiate a power off sequence during shutdown */
bool soft_shutdown;
int irq_base;
int gpio_base;
int gpio_defaults[WM831X_GPIO_NUM];
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment