Commit 52b9e6eb authored by Felipe Balbi's avatar Felipe Balbi

usb: musb: dsps: remove babble check from dsps irq handler

musb->int_usb already contains the correct
information for musb-core to handle babble.

In fact, this very check was just causing a
nonsensical babble interrupt storm.

With this I can get test.sh to run and, even though
all tests fail with timeout, that's still better
than locking up the system due to IRQ storm.

Also, if I remove g_zero and load g_mass_storage,
then everything works fine again.
Tested-by: default avatarBin Liu <b-liu@ti.com>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent b2c7361b
...@@ -879,7 +879,7 @@ static irqreturn_t musb_stage0_irq(struct musb *musb, u8 int_usb, ...@@ -879,7 +879,7 @@ static irqreturn_t musb_stage0_irq(struct musb *musb, u8 int_usb,
* the session. * the session.
*/ */
if (power & MUSB_POWER_HSMODE) { if (power & MUSB_POWER_HSMODE) {
ERR("Stopping host session -- babble\n"); dev_err(musb->controller, "Babble\n");
musb_writeb(musb->mregs, MUSB_DEVCTL, 0); musb_writeb(musb->mregs, MUSB_DEVCTL, 0);
if (is_host_active(musb)) { if (is_host_active(musb)) {
......
...@@ -330,28 +330,6 @@ static irqreturn_t dsps_interrupt(int irq, void *hci) ...@@ -330,28 +330,6 @@ static irqreturn_t dsps_interrupt(int irq, void *hci)
dev_dbg(musb->controller, "usbintr (%x) epintr(%x)\n", dev_dbg(musb->controller, "usbintr (%x) epintr(%x)\n",
usbintr, epintr); usbintr, epintr);
/*
* DRVVBUS IRQs are the only proxy we have (a very poor one!) for
* DSPS IP's missing ID change IRQ. We need an ID change IRQ to
* switch appropriately between halves of the OTG state machine.
* Managing DEVCTL.SESSION per Mentor docs requires that we know its
* value but DEVCTL.BDEVICE is invalid without DEVCTL.SESSION set.
* Also, DRVVBUS pulses for SRP (but not at 5V) ...
*/
if (is_host_active(musb) && usbintr & MUSB_INTR_BABBLE) {
pr_info("CAUTION: musb: Babble Interrupt Occurred\n");
/*
* When a babble condition occurs, the musb controller removes
* the session and is no longer in host mode. Hence, all
* devices connected to its root hub get disconnected.
*
* Hand this error down to the musb core isr, so it can
* recover.
*/
musb->int_usb = MUSB_INTR_BABBLE | MUSB_INTR_DISCONNECT;
musb->int_tx = musb->int_rx = 0;
}
if (usbintr & ((1 << wrp->drvvbus) << wrp->usb_shift)) { if (usbintr & ((1 << wrp->drvvbus) << wrp->usb_shift)) {
int drvvbus = dsps_readl(reg_base, wrp->status); int drvvbus = dsps_readl(reg_base, wrp->status);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment