irqdomain: Allow quiet failure mode

Some interrupt controllers refuse to map interrupts marked as
"protected" by firwmare. Since we try to map everyting in the
device-tree on some platforms, we end up with a lot of nasty
WARN's in the boot log for what is a normal situation on those
machines.

This defines a specific return code (-EPERM) from the host map()
callback which cause irqdomain to fail silently.

MPIC is updated to return this when hitting a protected source
printing only a single line message for diagnostic purposes.
Signed-off-by: default avatarBenjamin Herrenschmidt <benh@kernel.crashing.org>
parent f3d40c25
......@@ -1001,8 +1001,12 @@ static int mpic_host_map(struct irq_domain *h, unsigned int virq,
if (hw == mpic->spurious_vec)
return -EINVAL;
if (mpic->protected && test_bit(hw, mpic->protected))
return -EINVAL;
if (mpic->protected && test_bit(hw, mpic->protected)) {
pr_warning("mpic: Mapping of source 0x%x failed, "
"source protected by firmware !\n",\
(unsigned int)hw);
return -EPERM;
}
#ifdef CONFIG_SMP
else if (hw >= mpic->ipi_vecs[0]) {
......@@ -1029,8 +1033,12 @@ static int mpic_host_map(struct irq_domain *h, unsigned int virq,
if (mpic_map_error_int(mpic, virq, hw))
return 0;
if (hw >= mpic->num_sources)
if (hw >= mpic->num_sources) {
pr_warning("mpic: Mapping of source 0x%x failed, "
"source out of range !\n",\
(unsigned int)hw);
return -EINVAL;
}
mpic_msi_reserve_hwirq(mpic, hw);
......
......@@ -462,9 +462,23 @@ int irq_domain_associate_many(struct irq_domain *domain, unsigned int irq_base,
if (domain->ops->map) {
ret = domain->ops->map(domain, virq, hwirq);
if (ret != 0) {
/*
* If map() returns -EPERM, this interrupt is protected
* by the firmware or some other service and shall not
* be mapped.
*
* Since on some platforms we blindly try to map everything
* we end up with a log full of backtraces.
*
* So instead, we silently fail on -EPERM, it is the
* responsibility of the PIC driver to display a relevant
* message if needed.
*/
if (ret != -EPERM) {
pr_err("irq-%i==>hwirq-0x%lx mapping failed: %d\n",
virq, hwirq, ret);
WARN_ON(1);
}
irq_data->domain = NULL;
irq_data->hwirq = 0;
goto err_unmap;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment