USB: serial: fix potential stack buffer overflow

commit d979e9f9 upstream.

Make sure to verify the maximum number of endpoints per type to avoid
writing beyond the end of a stack-allocated array.

The current usb-serial implementation is limited to eight ports per
interface but failed to verify that the number of endpoints of a certain
type reported by a device did not exceed this limit.
Signed-off-by: Johan Hovold <johan@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
[lizf: Backported to 3.4: adjust context]
Signed-off-by: Zefan Li <lizefan@huawei.com>

drivers/usb/serial/usb-serial.c

@@ -794,31 +794,39 @@ int usb_serial_probe(struct usb_interface *interface,
 		if (usb_endpoint_is_bulk_in(endpoint)) {
 			/* we found a bulk in endpoint */
 			dbg("found bulk in on endpoint %d", i);
+			if (num_bulk_in < MAX_NUM_PORTS) {
 				bulk_in_endpoint[num_bulk_in] = endpoint;
 				++num_bulk_in;
 			}
+		}
 
 		if (usb_endpoint_is_bulk_out(endpoint)) {
 			/* we found a bulk out endpoint */
 			dbg("found bulk out on endpoint %d", i);
+			if (num_bulk_out < MAX_NUM_PORTS) {
 				bulk_out_endpoint[num_bulk_out] = endpoint;
 				++num_bulk_out;
 			}
+		}
 
 		if (usb_endpoint_is_int_in(endpoint)) {
 			/* we found a interrupt in endpoint */
 			dbg("found interrupt in on endpoint %d", i);
+			if (num_interrupt_in < MAX_NUM_PORTS) {
 				interrupt_in_endpoint[num_interrupt_in] = endpoint;
 				++num_interrupt_in;
 			}
+		}
 
 		if (usb_endpoint_is_int_out(endpoint)) {
 			/* we found an interrupt out endpoint */
 			dbg("found interrupt out on endpoint %d", i);
+			if (num_interrupt_out < MAX_NUM_PORTS) {
 				interrupt_out_endpoint[num_interrupt_out] = endpoint;
 				++num_interrupt_out;
 			}
 		}
+	}
 
 #if defined(CONFIG_USB_SERIAL_PL2303) || defined(CONFIG_USB_SERIAL_PL2303_MODULE)
 	/* BEGIN HORRIBLE HACK FOR PL2303 */
@@ -839,11 +847,13 @@ int usb_serial_probe(struct usb_interface *interface,
 				if (usb_endpoint_is_int_in(endpoint)) {
 					/* we found a interrupt in endpoint */
 					dbg("found interrupt in for Prolific device on separate interface");
+					if (num_interrupt_in < MAX_NUM_PORTS) {
 						interrupt_in_endpoint[num_interrupt_in] = endpoint;
 						++num_interrupt_in;
 					}
 				}
 			}
+		}
 
 		/* Now make sure the PL-2303 is configured correctly.
 		 * If not, give up now and hope this hack will work