Commit 621efefc authored by Hans de Goede's avatar Hans de Goede Committed by Maxime Ripard

ARM: dts: sun8i-q8-common: Add support for SDIO wifi controllers

Most of the sun8i q8 boards have an SDIO wifi controller, on the
variants which use an USB wifi controller, this will result in a
couple of error msg-s in dmesg when proving the sdio bus and
an used mmc controller.

The best way to deal with wifi on this boards really is to simply
let the kernel auto-detect usb or sdio wifi controllers, so we
will just have to live with the few errors in dmesg.

This has been tested on a23 based q8 tablets with ESP8089, RTL8703AS and
RTL8189FTV wifi controllers.
Signed-off-by: default avatarHans de Goede <hdegoede@redhat.com>
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
parent 2ea3c34b
...@@ -42,10 +42,59 @@ ...@@ -42,10 +42,59 @@
#include "sunxi-reference-design-tablet.dtsi" #include "sunxi-reference-design-tablet.dtsi"
#include "sun8i-reference-design-tablet.dtsi" #include "sun8i-reference-design-tablet.dtsi"
/ {
aliases {
serial0 = &r_uart;
/* Make u-boot set mac-address for wifi without an eeprom */
ethernet0 = &sdio_wifi;
};
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
/*
* Q8 boards use various PL# pins as wifi-en. On other boards
* these may be connected to a wifi module output pin. To avoid
* short-circuits we configure these as inputs with pull-ups via
* pinctrl, instead of listing them as active-low reset-gpios.
*/
pinctrl-names = "default";
pinctrl-0 = <&wifi_pwrseq_pin_q8>;
/* The esp8089 needs 200 ms after driving wifi-en high */
post-power-on-delay-ms = <200>;
};
};
&ehci0 { &ehci0 {
status = "okay"; status = "okay";
}; };
&mmc1 {
pinctrl-names = "default";
pinctrl-0 = <&mmc1_pins_a>;
vmmc-supply = <&reg_dldo1>;
mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
non-removable;
status = "okay";
sdio_wifi: sdio_wifi@1 {
reg = <1>;
};
};
&mmc1_pins_a {
allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
};
&r_pio {
wifi_pwrseq_pin_q8: wifi_pwrseq_pin@0 {
allwinner,pins = "PL6", "PL7", "PL11";
allwinner,function = "gpio_in";
allwinner,drive = <SUN4I_PINCTRL_10_MA>;
allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
};
};
&usbphy { &usbphy {
usb1_vbus-supply = <&reg_dldo1>; usb1_vbus-supply = <&reg_dldo1>;
}; };
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment