Commit 66c39dfc authored by Adrian Hunter's avatar Adrian Hunter Committed by Ulf Hansson

mmc: sdhci: Change to new way of doing re-tuning

Make use of mmc core support for re-tuning instead
of doing it all in the sdhci driver.

This patch also changes to flag the need for re-tuning
always after runtime suspend when tuning has been used
at initialization. Previously it was only done if
the re-tuning timer was in use.
Signed-off-by: default avatarAdrian Hunter <adrian.hunter@intel.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 6376f69d
......@@ -52,7 +52,6 @@ static void sdhci_finish_data(struct sdhci_host *);
static void sdhci_finish_command(struct sdhci_host *);
static int sdhci_execute_tuning(struct mmc_host *mmc, u32 opcode);
static void sdhci_tuning_timer(unsigned long data);
static void sdhci_enable_preset_value(struct sdhci_host *host, bool enable);
static int sdhci_pre_dma_transfer(struct sdhci_host *host,
struct mmc_data *data,
......@@ -254,17 +253,6 @@ static void sdhci_init(struct sdhci_host *host, int soft)
static void sdhci_reinit(struct sdhci_host *host)
{
sdhci_init(host, 0);
/*
* Retuning stuffs are affected by different cards inserted and only
* applicable to UHS-I cards. So reset these fields to their initial
* value when card is removed.
*/
if (host->flags & SDHCI_USING_RETUNING_TIMER) {
host->flags &= ~SDHCI_USING_RETUNING_TIMER;
del_timer_sync(&host->tuning_timer);
host->flags &= ~SDHCI_NEEDS_RETUNING;
}
sdhci_enable_card_detection(host);
}
......@@ -1353,7 +1341,6 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
struct sdhci_host *host;
int present;
unsigned long flags;
u32 tuning_opcode;
host = mmc_priv(mmc);
......@@ -1387,39 +1374,6 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
host->mrq->cmd->error = -ENOMEDIUM;
tasklet_schedule(&host->finish_tasklet);
} else {
u32 present_state;
present_state = sdhci_readl(host, SDHCI_PRESENT_STATE);
/*
* Check if the re-tuning timer has already expired and there
* is no on-going data transfer and DAT0 is not busy. If so,
* we need to execute tuning procedure before sending command.
*/
if ((host->flags & SDHCI_NEEDS_RETUNING) &&
!(present_state & (SDHCI_DOING_WRITE | SDHCI_DOING_READ)) &&
(present_state & SDHCI_DATA_0_LVL_MASK)) {
if (mmc->card) {
/* eMMC uses cmd21 but sd and sdio use cmd19 */
tuning_opcode =
mmc->card->type == MMC_TYPE_MMC ?
MMC_SEND_TUNING_BLOCK_HS200 :
MMC_SEND_TUNING_BLOCK;
/* Here we need to set the host->mrq to NULL,
* in case the pending finish_tasklet
* finishes it incorrectly.
*/
host->mrq = NULL;
spin_unlock_irqrestore(&host->lock, flags);
sdhci_execute_tuning(mmc, tuning_opcode);
spin_lock_irqsave(&host->lock, flags);
/* Restore original mmc_request structure */
host->mrq = mrq;
}
}
if (mrq->sbc && !(host->flags & SDHCI_AUTO_CMD23))
sdhci_send_command(host, mrq->sbc);
else
......@@ -2065,23 +2019,18 @@ static int sdhci_execute_tuning(struct mmc_host *mmc, u32 opcode)
}
out:
host->flags &= ~SDHCI_NEEDS_RETUNING;
if (tuning_count) {
host->flags |= SDHCI_USING_RETUNING_TIMER;
mod_timer(&host->tuning_timer, jiffies + tuning_count * HZ);
}
/*
* In case tuning fails, host controllers which support re-tuning can
* try tuning again at a later time, when the re-tuning timer expires.
* So for these controllers, we return 0. Since there might be other
* controllers who do not have this capability, we return error for
* them. SDHCI_USING_RETUNING_TIMER means the host is currently using
* a retuning timer to do the retuning for the card.
* In case tuning fails, host controllers which support
* re-tuning can try tuning again at a later time, when the
* re-tuning timer expires. So for these controllers, we
* return 0. Since there might be other controllers who do not
* have this capability, we return error for them.
*/
if (err && (host->flags & SDHCI_USING_RETUNING_TIMER))
err = 0;
}
host->mmc->retune_period = err ? 0 : tuning_count;
sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);
......@@ -2337,20 +2286,6 @@ static void sdhci_timeout_timer(unsigned long data)
spin_unlock_irqrestore(&host->lock, flags);
}
static void sdhci_tuning_timer(unsigned long data)
{
struct sdhci_host *host;
unsigned long flags;
host = (struct sdhci_host *)data;
spin_lock_irqsave(&host->lock, flags);
host->flags |= SDHCI_NEEDS_RETUNING;
spin_unlock_irqrestore(&host->lock, flags);
}
/*****************************************************************************\
* *
* Interrupt handling *
......@@ -2728,11 +2663,8 @@ int sdhci_suspend_host(struct sdhci_host *host)
{
sdhci_disable_card_detection(host);
/* Disable tuning since we are suspending */
if (host->flags & SDHCI_USING_RETUNING_TIMER) {
del_timer_sync(&host->tuning_timer);
host->flags &= ~SDHCI_NEEDS_RETUNING;
}
mmc_retune_timer_stop(host->mmc);
mmc_retune_needed(host->mmc);
if (!device_may_wakeup(mmc_dev(host->mmc))) {
host->ier = 0;
......@@ -2782,10 +2714,6 @@ int sdhci_resume_host(struct sdhci_host *host)
sdhci_enable_card_detection(host);
/* Set the re-tuning expiration flag */
if (host->flags & SDHCI_USING_RETUNING_TIMER)
host->flags |= SDHCI_NEEDS_RETUNING;
return ret;
}
......@@ -2822,11 +2750,8 @@ int sdhci_runtime_suspend_host(struct sdhci_host *host)
{
unsigned long flags;
/* Disable tuning since we are suspending */
if (host->flags & SDHCI_USING_RETUNING_TIMER) {
del_timer_sync(&host->tuning_timer);
host->flags &= ~SDHCI_NEEDS_RETUNING;
}
mmc_retune_timer_stop(host->mmc);
mmc_retune_needed(host->mmc);
spin_lock_irqsave(&host->lock, flags);
host->ier &= SDHCI_INT_CARD_INT;
......@@ -2869,10 +2794,6 @@ int sdhci_runtime_resume_host(struct sdhci_host *host)
spin_unlock_irqrestore(&host->lock, flags);
}
/* Set the re-tuning expiration flag */
if (host->flags & SDHCI_USING_RETUNING_TIMER)
host->flags |= SDHCI_NEEDS_RETUNING;
spin_lock_irqsave(&host->lock, flags);
host->runtime_suspended = false;
......@@ -3408,13 +3329,6 @@ int sdhci_add_host(struct sdhci_host *host)
init_waitqueue_head(&host->buf_ready_int);
if (host->version >= SDHCI_SPEC_300) {
/* Initialize re-tuning timer */
init_timer(&host->tuning_timer);
host->tuning_timer.data = (unsigned long)host;
host->tuning_timer.function = sdhci_tuning_timer;
}
sdhci_init(host, 0);
ret = request_threaded_irq(host->irq, sdhci_irq, sdhci_thread_irq,
......
......@@ -432,13 +432,11 @@ struct sdhci_host {
#define SDHCI_REQ_USE_DMA (1<<2) /* Use DMA for this req. */
#define SDHCI_DEVICE_DEAD (1<<3) /* Device unresponsive */
#define SDHCI_SDR50_NEEDS_TUNING (1<<4) /* SDR50 needs tuning */
#define SDHCI_NEEDS_RETUNING (1<<5) /* Host needs retuning */
#define SDHCI_AUTO_CMD12 (1<<6) /* Auto CMD12 support */
#define SDHCI_AUTO_CMD23 (1<<7) /* Auto CMD23 support */
#define SDHCI_PV_ENABLED (1<<8) /* Preset value enabled */
#define SDHCI_SDIO_IRQ_ENABLED (1<<9) /* SDIO irq enabled */
#define SDHCI_SDR104_NEEDS_TUNING (1<<10) /* SDR104/HS200 needs tuning */
#define SDHCI_USING_RETUNING_TIMER (1<<11) /* Host is using a retuning timer for the card */
#define SDHCI_USE_64_BIT_DMA (1<<12) /* Use 64-bit DMA */
#define SDHCI_HS400_TUNING (1<<13) /* Tuning for HS400 */
......@@ -504,7 +502,6 @@ struct sdhci_host {
unsigned int tuning_count; /* Timer count for re-tuning */
unsigned int tuning_mode; /* Re-tuning mode supported by host */
#define SDHCI_TUNING_MODE_1 0
struct timer_list tuning_timer; /* Timer for tuning */
struct sdhci_host_next next_data;
unsigned long private[0] ____cacheline_aligned;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment