i2c: tegra: use readl_poll_timeout after config_load reg programmed

After CONFIG_LOAD register is programmed instead of explicitly waiting
for timeout, use readl_poll_timeout() to check for register value to get
updated or wait till timeout.
Signed-off-by: Shardar Shariff Md <smohammed@nvidia.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-tegra.c

@@ -30,6 +30,7 @@
 #include <linux/reset.h>
 #include <linux/pinctrl/consumer.h>
 #include <linux/pm_runtime.h>
+#include <linux/iopoll.h>
 
 #include <asm/unaligned.h>
 
@@ -112,6 +113,8 @@
 #define I2C_CLKEN_OVERRIDE			0x090
 #define I2C_MST_CORE_CLKEN_OVR			BIT(0)
 
+#define I2C_CONFIG_LOAD_TIMEOUT			1000000
+
 /*
  * msg_end_type: The bus control which need to be send at end of transfer.
  * @MSG_END_STOP: Send stop pulse at end of transfer.
@@ -448,7 +451,6 @@ static int tegra_i2c_init(struct tegra_i2c_dev *i2c_dev)
 	u32 val;
 	int err;
 	u32 clk_divisor;
-	unsigned long timeout = jiffies + HZ;
 
 	err = pm_runtime_get_sync(i2c_dev->dev);
 	if (err < 0) {
@@ -497,15 +499,18 @@ static int tegra_i2c_init(struct tegra_i2c_dev *i2c_dev)
 		i2c_writel(i2c_dev, I2C_MST_CORE_CLKEN_OVR, I2C_CLKEN_OVERRIDE);
 
 	if (i2c_dev->hw->has_config_load_reg) {
+		unsigned long reg_offset;
+		void __iomem *addr;
+
+		reg_offset = tegra_i2c_reg_addr(i2c_dev, I2C_CONFIG_LOAD);
+		addr = i2c_dev->base + reg_offset;
 		i2c_writel(i2c_dev, I2C_MSTR_CONFIG_LOAD, I2C_CONFIG_LOAD);
-		while (i2c_readl(i2c_dev, I2C_CONFIG_LOAD) != 0) {
-			if (time_after(jiffies, timeout)) {
-				dev_warn(i2c_dev->dev,
-					"timeout waiting for config load\n");
-				err = -ETIMEDOUT;
-				goto err;
-			}
-			msleep(1);
+		err = readl_poll_timeout(addr, val, val == 0, 1000,
+					 I2C_CONFIG_LOAD_TIMEOUT);
+		if (err) {
+			dev_warn(i2c_dev->dev,
+				 "timeout waiting for config load\n");
+			goto err;
 		}
 	}