gpio: stmpe: Write int status register only when needed

On STMPE801/1801 datasheets, it's mentionned writing
in interrupt status register has no effect, bits are
cleared when reading.
Signed-off-by: Amelie DELAUNAY <amelie.delaunay@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

drivers/gpio/gpio-stmpe.c

@@ -371,13 +371,17 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
 			stat &= ~(1 << bit);
 		}
 
+		/*
+		 * interrupt status register write has no effect on
+		 * 801 and 1801, bits are cleared when read.
+		 * Edge detect register is not present on 801 and 1801
+		 */
+		if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) {
 			stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
-
-		/* Edge detect register is not present on 801 and 1801 */
-		if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801)
 			stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB]
 					+ i, status[i]);
 		}
+	}
 
 	return IRQ_HANDLED;
 }