misc: mic: fix a DMA pool free failure

In _scif_prog_signal(), the boolean variable 'x100' is used to indicate
whether the MIC Coprocessor is X100. If 'x100' is true, the status
descriptor will be used to write the value to the destination. Otherwise, a
DMA pool will be allocated for this purpose. Specifically, if the DMA pool
is allocated successfully, two memory addresses will be returned. One is
for the CPU and the other is for the device to access the DMA pool. The
former is stored to the variable 'status' and the latter is stored to the
variable 'src'. After the allocation, the address in 'src' is saved to
'status->src_dma_addr', which is actually in the DMA pool, and 'src' is
then modified.

Later on, if an error occurs, the execution flow will transfer to the label
'dma_fail', which will check 'x100' and free up the allocated DMA pool if
'x100' is false. The point here is that 'status->src_dma_addr' is used for
freeing up the DMA pool. As mentioned before, 'status->src_dma_addr' is in
the DMA pool. And thus, the device is able to modify this data. This can
potentially cause failures when freeing up the DMA pool because of the
modified device address.

This patch avoids the above issue by using the variable 'src' (with
necessary calculation) to free up the DMA pool.
Signed-off-by: Wenwen Wang <wang6495@umn.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/misc/mic/scif/scif_fence.c

@@ -272,7 +272,7 @@ static int _scif_prog_signal(scif_epd_t epd, dma_addr_t dst, u64 val)
 dma_fail:
 	if (!x100)
 		dma_pool_free(ep->remote_dev->signal_pool, status,
-			      status->src_dma_addr);
+			      src - offsetof(struct scif_status, val));
 alloc_fail:
 	return err;
 }