dt-bindings: pinctrl-zynqmp: Add output-enable configuration

Add 'output-enable' configuration parameter to the properties list.

Using these pinctrl properties observed hang issues with older Xilinx
ZynqMP Platform Management Firmware, hence reverted the patch previously.
Commit ff835606 ("Revert "dt-bindings: pinctrl-zynqmp: Add
output-enable configuration"").

Support for configuring these properties added in Xilinx ZynqMP Platform
Management firmware(PMUFW) Configuration Set version 2.0. Linux firmware
driver checks if the configuration is supported by the PMUFW when it gets
request for TRISTATE configuration from pinctrl driver. If it supports,
then calls will be made otherwise it returns error.
Signed-off-by: Sai Krishna Potthuri <sai.krishna.potthuri@amd.com>
Acked-by: Conor Dooley <conor.dooley@microchip.com>
Link: https://lore.kernel.org/r/20230731095026.3766675-4-sai.krishna.potthuri@amd.comSigned-off-by: Linus Walleij <linus.walleij@linaro.org>

Documentation/devicetree/bindings/pinctrl/xlnx,zynqmp-pinctrl.yaml

@@ -273,6 +273,10 @@ patternProperties:
           slew-rate:
             enum: [0, 1]
 
+          output-enable:
+            description:
+              This will internally disable the tri-state for MIO pins.
+
           drive-strength:
             description:
               Selects the drive strength for MIO pins, in mA.