[SCSI] add DID_REQUEUE string to scsi_show_result host table

I was working on patches which add new transport error values, when I
noticed that DID_REQUEUE was not in the hostbyte_table. I do not think
there is any way to hit the code path where scsi_show_result is called
and where you return DID_REQUEUE, because DID_REQUEUE causes scsi-ml to
always requeue the command. However, for completeness and because I want
to one day send a patch that tries to add new host bytes values, I am
sending this patch.
Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/constants.c

@@ -1369,7 +1369,7 @@ EXPORT_SYMBOL(scsi_print_sense);
 static const char * const hostbyte_table[]={
 "DID_OK", "DID_NO_CONNECT", "DID_BUS_BUSY", "DID_TIME_OUT", "DID_BAD_TARGET",
 "DID_ABORT", "DID_PARITY", "DID_ERROR", "DID_RESET", "DID_BAD_INTR",
-"DID_PASSTHROUGH", "DID_SOFT_ERROR", "DID_IMM_RETRY"};
+"DID_PASSTHROUGH", "DID_SOFT_ERROR", "DID_IMM_RETRY", "DID_REQUEUE"};
 #define NUM_HOSTBYTE_STRS ARRAY_SIZE(hostbyte_table)
 
 static const char * const driverbyte_table[]={