iio: pressure: Support ROHM BU1390

Support for the ROHM BM1390 pressure sensor. The BM1390GLV-Z can measure
pressures ranging from 300 hPa to 1300 hPa with configurable measurement
averaging and internal FIFO. The sensor does also provide temperature
measurements.

Sensor does also contain IIR filter implemented in HW. The data-sheet
says the IIR filter can be configured to be "weak", "middle" or
"strong". Some RMS noise figures are provided in data sheet but no
accurate maths for the filter configurations is provided. Hence, the IIR
filter configuration is not supported by this driver and the filter is
configured to the "middle" setting (at least not for now).

The FIFO measurement mode is only measuring the pressure and not the
temperature. The driver measures temperature when FIFO is flushed and
simply uses the same measured temperature value to all reported
temperatures. This should not be a problem when temperature is not
changing very rapidly (several degrees C / second) but allows users to
get the temperature measurements from sensor without any additional logic.

This driver allows the sensor to be used in two muitually exclusive ways,

1. With trigger (data-ready IRQ).
In this case the FIFO is not used as we get data ready for each collected
sample. Instead, for each data-ready IRQ we read the sample from sensor
and push it to the IIO buffer.

2. With hardware FIFO and watermark IRQ.
In this case the data-ready is not used but we enable watermark IRQ. At
each watermark IRQ we go and read all samples in FIFO and push them to the
IIO buffer.
Signed-off-by: Matti Vaittinen <mazziesaccount@gmail.com>
Link: https://lore.kernel.org/r/4f23211e3cf248f9f48ddb2a752387bb00e9c2c4.1695727471.git.mazziesaccount@gmail.comSigned-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

drivers/iio/pressure/Kconfig

@@ -16,6 +16,15 @@ config ABP060MG
 	  To compile this driver as a module, choose M here: the module
 	  will be called abp060mg.
 
+config ROHM_BM1390
+	tristate "ROHM BM1390GLV-Z pressure sensor driver"
+	depends on I2C
+	help
+	  Support for the ROHM BM1390 pressure sensor. The BM1390GLV-Z
+	  can measure pressures ranging from 300 hPa to 1300 hPa with
+	  configurable measurement averaging and internal FIFO. The
+	  sensor does also provide temperature measurements.
+
 config BMP280
 	tristate "Bosch Sensortec BMP180/BMP280/BMP380/BMP580 pressure sensor driver"
 	depends on (I2C || SPI_MASTER)

drivers/iio/pressure/Makefile

@@ -5,6 +5,7 @@
 
 # When adding new entries keep the list in alphabetical order
 obj-$(CONFIG_ABP060MG) += abp060mg.o
+obj-$(CONFIG_ROHM_BM1390) += rohm-bm1390.o
 obj-$(CONFIG_BMP280) += bmp280.o
 bmp280-objs := bmp280-core.o bmp280-regmap.o
 obj-$(CONFIG_BMP280_I2C) += bmp280-i2c.o