Commit 82c2ffeb authored by Javier Martinez Canillas's avatar Javier Martinez Canillas Committed by Mauro Carvalho Chehab

[media] tvp5150: document input connectors DT bindings

The tvp5150 decoder has different input connectors so extend the device
tree binding to allow device tree source files to define the connectors
that are available on a given board.
Signed-off-by: default avatarJavier Martinez Canillas <javier@osg.samsung.com>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@osg.samsung.com>
parent b802fb99
...@@ -12,6 +12,32 @@ Optional Properties: ...@@ -12,6 +12,32 @@ Optional Properties:
- pdn-gpios: phandle for the GPIO connected to the PDN pin, if any. - pdn-gpios: phandle for the GPIO connected to the PDN pin, if any.
- reset-gpios: phandle for the GPIO connected to the RESETB pin, if any. - reset-gpios: phandle for the GPIO connected to the RESETB pin, if any.
Optional nodes:
- connectors: The input connectors of tvp5150 have to be defined under
a subnode name "connectors" using the following format:
input-connector-name {
input connector properties
};
Each input connector must contain the following properties:
- label: a name for the connector.
- input: the input connector.
The possible values for the "input" property are:
0: Composite0
1: Composite1
2: S-Video
and on a tvp5150am1 and tvp5151 there is another:
4: Signal generator
The list of valid input connectors are defined in dt-bindings/media/tvp5150.h
header file and can be included by device tree source files.
Each input connector can be defined only once.
The device node must contain one 'port' child node for its digital output The device node must contain one 'port' child node for its digital output
video port, in accordance with the video interface bindings defined in video port, in accordance with the video interface bindings defined in
Documentation/devicetree/bindings/media/video-interfaces.txt. Documentation/devicetree/bindings/media/video-interfaces.txt.
...@@ -36,6 +62,23 @@ Example: ...@@ -36,6 +62,23 @@ Example:
pdn-gpios = <&gpio4 30 GPIO_ACTIVE_LOW>; pdn-gpios = <&gpio4 30 GPIO_ACTIVE_LOW>;
reset-gpios = <&gpio6 7 GPIO_ACTIVE_LOW>; reset-gpios = <&gpio6 7 GPIO_ACTIVE_LOW>;
connectors {
composite0 {
label = "Composite0";
input = <TVP5150_COMPOSITE0>;
};
composite1 {
label = "Composite1";
input = <TVP5150_COMPOSITE1>;
};
s-video {
label = "S-Video";
input = <TVP5150_SVIDEO>;
};
};
port { port {
tvp5150_1: endpoint { tvp5150_1: endpoint {
remote-endpoint = <&ccdc_ep>; remote-endpoint = <&ccdc_ep>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment