mmc: sdhci: Balance vmmc regulator_enable(), and always enable vqmmc

The vmmc regulator enable in sdhci_add_host is NOT necessary since
it can be enabled during mmc_power_up by function mmc_regulator_set_ocr.
And this extra enable will make regulator_enable/regulator_disable
unbalanced. Consequently, vmmc can't be disabled during mmc_power_off.

Also, if the vqmmc regulator exists, it should be enabled regardless it
support 1.8v or not.
Signed-off-by: Kevin Liu <kliu5@marvell.com>
Signed-off-by: Philip Rakity <prakity@marvell.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

drivers/mmc/host/sdhci.c

@@ -2858,12 +2858,14 @@ int sdhci_add_host(struct sdhci_host *host)
 				mmc_hostname(mmc));
 			host->vqmmc = NULL;
 		}
-	}
-	else if (regulator_is_supported_voltage(host->vqmmc, 1800000, 1800000))
+	} else {
 		regulator_enable(host->vqmmc);
-	else
-		caps[1] &= ~(SDHCI_SUPPORT_SDR104 | SDHCI_SUPPORT_SDR50 |
+		if (!regulator_is_supported_voltage(host->vqmmc, 1800000,
+			1800000))
+			caps[1] &= ~(SDHCI_SUPPORT_SDR104 |
+					SDHCI_SUPPORT_SDR50 |
 					SDHCI_SUPPORT_DDR50);
+	}
 
 	/* Any UHS-I mode in caps implies SDR12 and SDR25 support. */
 	if (caps[1] & (SDHCI_SUPPORT_SDR104 | SDHCI_SUPPORT_SDR50 |
@@ -2919,8 +2921,7 @@ int sdhci_add_host(struct sdhci_host *host)
 				mmc_hostname(mmc));
 			host->vmmc = NULL;
 		}
-	} else
-		regulator_enable(host->vmmc);
+	}
 
 #ifdef CONFIG_REGULATOR
 	if (host->vmmc) {