Commit 84c09d72 authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab

[media] cx231xx: Improve signal reception for PV SBTVD

Instead of using 3.3 MHz IF, use 4MHz. That's the standard
value for the demod, and, while it can be adjusted, 3.3 MHz
is out of the recommended range. So, let's stick with the
default.
With regards to the IF voltage level, instead of using
0.5 V(p-p) for IF, use 2V, giving a 12dB gain.
The rationale is that, on PixelView SBTVD Hybrid,
even 2V(p-p) would be in the nominal range for IF,
as the maximum range on this particular device is 3V.
A higher gain here should help to improve reception under
weak signals.
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@redhat.com>
parent 3a2e4751
...@@ -89,8 +89,8 @@ static struct tda18271_std_map cnxt_rde253s_tda18271_std_map = { ...@@ -89,8 +89,8 @@ static struct tda18271_std_map cnxt_rde253s_tda18271_std_map = {
}; };
static struct tda18271_std_map mb86a20s_tda18271_config = { static struct tda18271_std_map mb86a20s_tda18271_config = {
.dvbt_6 = { .if_freq = 3300, .agc_mode = 3, .std = 4, .dvbt_6 = { .if_freq = 4000, .agc_mode = 3, .std = 4,
.if_lvl = 7, .rfagc_top = 0x37, }, .if_lvl = 0, .rfagc_top = 0x37, },
}; };
static struct tda18271_config cnxt_rde253s_tunerconfig = { static struct tda18271_config cnxt_rde253s_tunerconfig = {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment