Commit 87652644 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller

dl2k: convert to net_device_ops

Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 0421eae6
...@@ -85,6 +85,19 @@ static int mii_write (struct net_device *dev, int phy_addr, int reg_num, ...@@ -85,6 +85,19 @@ static int mii_write (struct net_device *dev, int phy_addr, int reg_num,
static const struct ethtool_ops ethtool_ops; static const struct ethtool_ops ethtool_ops;
static const struct net_device_ops netdev_ops = {
.ndo_open = rio_open,
.ndo_start_xmit = start_xmit,
.ndo_stop = rio_close,
.ndo_get_stats = get_stats,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = eth_mac_addr,
.ndo_set_multicast_list = set_multicast,
.ndo_do_ioctl = rio_ioctl,
.ndo_tx_timeout = rio_tx_timeout,
.ndo_change_mtu = change_mtu,
};
static int __devinit static int __devinit
rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent) rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
{ {
...@@ -197,15 +210,8 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent) ...@@ -197,15 +210,8 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
else if (tx_coalesce > TX_RING_SIZE-1) else if (tx_coalesce > TX_RING_SIZE-1)
tx_coalesce = TX_RING_SIZE - 1; tx_coalesce = TX_RING_SIZE - 1;
} }
dev->open = &rio_open; dev->netdev_ops = &netdev_ops;
dev->hard_start_xmit = &start_xmit;
dev->stop = &rio_close;
dev->get_stats = &get_stats;
dev->set_multicast_list = &set_multicast;
dev->do_ioctl = &rio_ioctl;
dev->tx_timeout = &rio_tx_timeout;
dev->watchdog_timeo = TX_TIMEOUT; dev->watchdog_timeo = TX_TIMEOUT;
dev->change_mtu = &change_mtu;
SET_ETHTOOL_OPS(dev, &ethtool_ops); SET_ETHTOOL_OPS(dev, &ethtool_ops);
#if 0 #if 0
dev->features = NETIF_F_IP_CSUM; dev->features = NETIF_F_IP_CSUM;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment