dt-bindings: power: supply: lt3651: Convert to DT schema format

Convert the binding to DT schema format.
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Reviewed-by: Rob Herring <robh@kernel.org>

Documentation/devicetree/bindings/power/supply/lltc,lt3651-charger.yaml

+# SPDX-License-Identifier: GPL-2.0
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/power/supply/lltc,lt3651-charger.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: Analog Devices LT3651 Charger Power Supply bindings
+
+maintainers:
+  - Sebastian Reichel <sre@kernel.org>
+
+allOf:
+  - $ref: power-supply.yaml#
+
+properties:
+  compatible:
+    enum:
+      - lltc,lt3651-charger
+      - lltc,ltc3651-charger  # deprecated, use lltc,lt3651-charger
+
+  lltc,acpr-gpios:
+    maxItems: 1
+
+  lltc,fault-gpios:
+    maxItems: 1
+
+  lltc,chrg-gpios:
+    maxItems: 1
+
+required:
+  - compatible
+  - lltc,acpr-gpios
+
+additionalProperties: false
+
+examples:
+  - |
+    #include <dt-bindings/gpio/gpio.h>
+    charger {
+      compatible = "lltc,lt3651-charger";
+      lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
+      lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
+      lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
+    };

Documentation/devicetree/bindings/power/supply/lt3651-charger.txt

-Analog Devices LT3651 Charger Power Supply bindings: lt3651-charger
-
-Required properties:
-- compatible: Should contain one of the following:
- * "lltc,ltc3651-charger", (DEPRECATED: Use "lltc,lt3651-charger")
- * "lltc,lt3651-charger"
- - lltc,acpr-gpios: Connect to ACPR output. See remark below.
-
-Optional properties:
- - lltc,fault-gpios: Connect to FAULT output. See remark below.
- - lltc,chrg-gpios: Connect to CHRG output. See remark below.
-
-The lt3651 outputs are open-drain type and active low. The driver assumes the
-GPIO reports "active" when the output is asserted, so if the pins have been
-connected directly, the GPIO flags should be set to active low also.
-
-The driver will attempt to aquire interrupts for all GPIOs to detect changes in
-line state. If the system is not capabale of providing interrupts, the driver
-cannot report changes and userspace will need to periodically read the sysfs
-attributes to detect changes.
-
-Example:
-
-	charger: battery-charger {
-		compatible = "lltc,lt3651-charger";
-		lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
-		lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
-		lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
-	};