thermal: exynos: remove redundant pdata checks from exynos_tmu_control()

pdata->reference_voltage and pdata->gain are always defined
to non-zero values so remove the redundant checks from
exynos_tmu_control().

There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>
Tested-by: Amit Daniel Kachhap <amit.daniel@samsung.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>

drivers/thermal/samsung/exynos_tmu.c

@@ -274,15 +274,11 @@ static void exynos_tmu_control(struct platform_device *pdev, bool on)
 	if (pdata->test_mux)
 		con |= (pdata->test_mux << reg->test_mux_addr_shift);
 
-	if (pdata->reference_voltage) {
 	con &= ~(reg->buf_vref_sel_mask << reg->buf_vref_sel_shift);
 	con |= pdata->reference_voltage << reg->buf_vref_sel_shift;
-	}
 
-	if (pdata->gain) {
 	con &= ~(reg->buf_slope_sel_mask << reg->buf_slope_sel_shift);
 	con |= (pdata->gain << reg->buf_slope_sel_shift);
-	}
 
 	if (pdata->noise_cancel_mode) {
 		con &= ~(reg->therm_trip_mode_mask <<

drivers/thermal/samsung/exynos_tmu.h

@@ -201,10 +201,10 @@ struct exynos_tmu_registers {
  * @max_trigger_level: max trigger level supported by the TMU
  * @non_hw_trigger_levels: number of defined non-hardware trigger levels
  * @gain: gain of amplifier in the positive-TC generator block
- *	0 <= gain <= 15
+ *	0 < gain <= 15
  * @reference_voltage: reference voltage of amplifier
  *	in the positive-TC generator block
- *	0 <= reference_voltage <= 31
+ *	0 < reference_voltage <= 31
  * @noise_cancel_mode: noise cancellation mode
  *	000, 100, 101, 110 and 111 can be different modes
  * @type: determines the type of SOC