m68k: Set ColdFire ACR1 cache mode depending on kernel configuration

For coldfire with MMU enabled, data cache did not follow the configuration but
was configured in writethrough mode.
Signed-off-by: Stany MARCEL <stany.marcel@novasys-ingenierie.com>
Signed-off-by: Greg Ungerer <gerg@uclinux.org>

arch/m68k/include/asm/m54xxacr.h

@@ -96,8 +96,13 @@
  */
 #define ACR0_MODE	(ACR_BA(CONFIG_MBAR)+ACR_ADMSK(0x1000000)+ \
 			 ACR_ENABLE+ACR_SUPER+ACR_CM_OFF_PRE+ACR_SP)
+#if defined(CONFIG_CACHE_COPYBACK)
 #define ACR1_MODE	(ACR_BA(CONFIG_RAMBASE)+ACR_ADMSK(CONFIG_RAMSIZE)+ \
-			 ACR_ENABLE+ACR_SUPER+ACR_SP)
+			 ACR_ENABLE+ACR_SUPER+ACR_SP+ACR_CM_CP)
+#else
+#define ACR1_MODE	(ACR_BA(CONFIG_RAMBASE)+ACR_ADMSK(CONFIG_RAMSIZE)+ \
+			 ACR_ENABLE+ACR_SUPER+ACR_SP+ACR_CM_WT)
+#endif
 #define ACR2_MODE	0
 #define ACR3_MODE	(ACR_BA(CONFIG_RAMBASE)+ACR_ADMSK(CONFIG_RAMSIZE)+ \
 			 ACR_ENABLE+ACR_SUPER+ACR_SP)