perf: imx_perf: fix counter start and config sequence

In current driver, the counter will start firstly and then be configured.
This sequence is not correct for AXI filter events since the correct
AXI_MASK and AXI_ID are not set yet. Then the results may be inaccurate.
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Fixes: 55691f99 ("drivers/perf: imx_ddr: Add support for NXP i.MX9 SoC DDRC PMU driver")
cc: stable@vger.kernel.org
Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
Link: https://lore.kernel.org/r/20240529080358.703784-5-xu.yang_2@nxp.comSigned-off-by: Will Deacon <will@kernel.org>

drivers/perf/fsl_imx9_ddr_perf.c

@@ -541,12 +541,12 @@ static int ddr_perf_event_add(struct perf_event *event, int flags)
 	hwc->idx = counter;
 	hwc->state |= PERF_HES_STOPPED;
 
-	if (flags & PERF_EF_START)
-		ddr_perf_event_start(event, flags);
-
 	/* read trans, write trans, read beat */
 	imx93_ddr_perf_monitor_config(pmu, event_id, counter, cfg1, cfg2);
 
+	if (flags & PERF_EF_START)
+		ddr_perf_event_start(event, flags);
+
 	return 0;
 }