ARM: dts: ux500: Fix up the thermal nodes

The thermal driver for the DB8500 was never properly converted
to device tree, the node should definitely be activated for
all board variants so move this down into the main SoC
DTSI, and default on.
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/boot/dts/ste-dbx5x0.dtsi

@@ -505,10 +505,30 @@ prcmu-timer-4@80157450 {
 			thermal@801573c0 {
 				compatible = "stericsson,db8500-thermal";
 				reg = <0x801573c0 0x40>;
+				interrupt-parent = <&prcmu>;
 				interrupts = <21 IRQ_TYPE_LEVEL_HIGH>,
 					     <22 IRQ_TYPE_LEVEL_HIGH>;
 				interrupt-names = "IRQ_HOTMON_LOW", "IRQ_HOTMON_HIGH";
-				status = "disabled";
+				num-trips = <4>;
+
+				trip0-temp = <70000>;
+				trip0-type = "active";
+				trip0-cdev-num = <1>;
+				trip0-cdev-name0 = "thermal-cpufreq-0";
+
+				trip1-temp = <75000>;
+				trip1-type = "active";
+				trip1-cdev-num = <1>;
+				trip1-cdev-name0 = "thermal-cpufreq-0";
+
+				trip2-temp = <80000>;
+				trip2-type = "active";
+				trip2-cdev-num = <1>;
+				trip2-cdev-name0 = "thermal-cpufreq-0";
+
+				trip3-temp = <85000>;
+				trip3-type = "critical";
+				trip3-cdev-num = <0>;
 			};
 
 			db8500-prcmu-regulators {

arch/arm/boot/dts/ste-snowball.dts

@@ -376,40 +376,11 @@ spi@80002000 {
 			pinctrl-0 = <&ssp0_snowball_mode>;
 		};
 
-		cpufreq-cooling {
-			status = "okay";
-		};
-
 		prcmu@80157000 {
 			cpufreq {
 				status = "okay";
 			};
 
-			thermal@801573c0 {
-				num-trips = <4>;
-
-				trip0-temp = <70000>;
-				trip0-type = "active";
-				trip0-cdev-num = <1>;
-				trip0-cdev-name0 = "thermal-cpufreq-0";
-
-				trip1-temp = <75000>;
-				trip1-type = "active";
-				trip1-cdev-num = <1>;
-				trip1-cdev-name0 = "thermal-cpufreq-0";
-
-				trip2-temp = <80000>;
-				trip2-type = "active";
-				trip2-cdev-num = <1>;
-				trip2-cdev-name0 = "thermal-cpufreq-0";
-
-				trip3-temp = <85000>;
-				trip3-type = "critical";
-				trip3-cdev-num = <0>;
-
-				status = "okay";
-			};
-
 			ab8500 {
 				ab8500-gpio {
 					/*