media: qcom: camss: Remove special case for VFE get/put

From sdm845 onwards we need to ensure the VFE is powered on prior to
switching on the CSID.

Currently the code tests for sdm845, sm8250 and then does get/set. This is
not extensible and it turns out is not necessary either since vfe_get and
vfe_set reference count.

Remove the over-conservative SoC version check.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Suggested-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> # rb3 # db410c
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>

drivers/media/platform/qcom/camss/camss-csid.c

@@ -159,15 +159,17 @@ static int csid_set_power(struct v4l2_subdev *sd, int on)
 	struct camss *camss = csid->camss;
 	struct device *dev = camss->dev;
 	struct vfe_device *vfe = &camss->vfe[csid->id];
-	u32 version = camss->res->version;
 	int ret = 0;
 
 	if (on) {
-		if (version == CAMSS_8250 || version == CAMSS_845) {
+		/*
+		 * From SDM845 onwards, the VFE needs to be powered on before
+		 * switching on the CSID. Do so unconditionally, as there is no
+		 * drawback in following the same powering order on older SoCs.
+		 */
 		ret = vfe_get(vfe);
 		if (ret < 0)
 			return ret;
-		}
 
 		ret = pm_runtime_resume_and_get(dev);
 		if (ret < 0)
@@ -217,7 +219,6 @@ static int csid_set_power(struct v4l2_subdev *sd, int on)
 		regulator_bulk_disable(csid->num_supplies,
 				       csid->supplies);
 		pm_runtime_put_sync(dev);
-		if (version == CAMSS_8250 || version == CAMSS_845)
 		vfe_put(vfe);
 	}