Skip to content

L
linux
Commit b55ccb35 authored by Jeff Kirsher's avatar Jeff Kirsher Committed by Jeff Garzik
Browse files
Options

[PATCH] e1000: Fix ASF/AMT for 8257{1|2|3} controllers 

The 82573 controller required different logic than 82571|2 controllers.  Corrected the reset logic for 8257{1|2|3} controllers.
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: default avatarJesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: default avatarJohn Ronciak <john.ronciak@intel.com>
Signed-off-by: default avatarJeff Garzik <jgarzik@pobox.com>
parent 57128197
Show whitespace changes
Inline Side-by-side
Showing with 107 additions and 70 deletions
drivers/net/e1000/e1000_hw.c
View file @ b55ccb35
......@@ -2982,6 +2982,8 @@ e1000_phy_hw_reset(struct e1000_hw *hw)
if (hw->mac_type < e1000_82571)
msec_delay(10);
else
udelay(100);
E1000_WRITE_REG(hw, CTRL, ctrl);
E1000_WRITE_FLUSH(hw);
......
drivers/net/e1000/e1000_main.c
View file @ b55ccb35
......@@ -320,6 +320,74 @@ e1000_update_mng_vlan(struct e1000_adapter *adapter)
}
}
/**
* e1000_release_hw_control - release control of the h/w to f/w
* @adapter: address of board private structure
*
* e1000_release_hw_control resets {CTRL_EXT|FWSM}:DRV_LOAD bit.
* For ASF and Pass Through versions of f/w this means that the
* driver is no longer loaded. For AMT version (only with 82573) i
* of the f/w this means that the netowrk i/f is closed.
*
**/
static inline void
e1000_release_hw_control(struct e1000_adapter *adapter)
{
uint32_t ctrl_ext;
uint32_t swsm;
/* Let firmware taken over control of h/w */
switch (adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm & ~E1000_SWSM_DRV_LOAD);
default:
break;
}
}
/**
* e1000_get_hw_control - get control of the h/w from f/w
* @adapter: address of board private structure
*
* e1000_get_hw_control sets {CTRL_EXT|FWSM}:DRV_LOAD bit.
* For ASF and Pass Through versions of f/w this means that
* the driver is loaded. For AMT version (only with 82573)
* of the f/w this means that the netowrk i/f is open.
*
**/
static inline void
e1000_get_hw_control(struct e1000_adapter *adapter)
{
uint32_t ctrl_ext;
uint32_t swsm;
/* Let firmware know the driver has taken over */
switch (adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm | E1000_SWSM_DRV_LOAD);
break;
default:
break;
}
}
int
e1000_up(struct e1000_adapter *adapter)
{
......@@ -523,8 +591,6 @@ e1000_probe(struct pci_dev *pdev,
struct net_device *netdev;
struct e1000_adapter *adapter;
unsigned long mmio_start, mmio_len;
uint32_t ctrl_ext;
uint32_t swsm;
static int cards_found = 0;
int i, err, pci_using_dac;
......@@ -736,22 +802,13 @@ e1000_probe(struct pci_dev *pdev,
/* reset the hardware with the new settings */
e1000_reset(adapter);
/* Let firmware know the driver has taken over */
switch(adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm | E1000_SWSM_DRV_LOAD);
break;
default:
break;
}
/* If the controller is 82573 and f/w is AMT, do not set
* DRV_LOAD until the interface is up. For all other cases,
* let the f/w know that the h/w is now under the control
* of the driver. */
if (adapter->hw.mac_type != e1000_82573 ||
!e1000_check_mng_mode(&adapter->hw))
e1000_get_hw_control(adapter);
strcpy(netdev->name, "eth%d");
if((err = register_netdev(netdev)))
......@@ -788,8 +845,7 @@ e1000_remove(struct pci_dev *pdev)
{
struct net_device *netdev = pci_get_drvdata(pdev);
struct e1000_adapter *adapter = netdev_priv(netdev);
uint32_t ctrl_ext;
uint32_t manc, swsm;
uint32_t manc;
#ifdef CONFIG_E1000_NAPI
int i;
#endif
......@@ -805,22 +861,9 @@ e1000_remove(struct pci_dev *pdev)
}
}
switch(adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm & ~E1000_SWSM_DRV_LOAD);
break;
default:
break;
}
/* Release control of h/w to f/w. If f/w is AMT enabled, this
* would have already happened in close and is redundant. */
e1000_release_hw_control(adapter);
unregister_netdev(netdev);
#ifdef CONFIG_E1000_NAPI
......@@ -1077,6 +1120,12 @@ e1000_open(struct net_device *netdev)
e1000_update_mng_vlan(adapter);
}
/* If AMT is enabled, let the firmware know that the network
* interface is now open */
if (adapter->hw.mac_type == e1000_82573 &&
e1000_check_mng_mode(&adapter->hw))
e1000_get_hw_control(adapter);
return E1000_SUCCESS;
err_up:
......@@ -1115,6 +1164,13 @@ e1000_close(struct net_device *netdev)
E1000_MNG_DHCP_COOKIE_STATUS_VLAN_SUPPORT)) {
e1000_vlan_rx_kill_vid(netdev, adapter->mng_vlan_id);
}
/* If AMT is enabled, let the firmware know that the network
* interface is now closed */
if (adapter->hw.mac_type == e1000_82573 &&
e1000_check_mng_mode(&adapter->hw))
e1000_release_hw_control(adapter);
return 0;
}
......@@ -4182,7 +4238,7 @@ e1000_suspend(struct pci_dev *pdev, pm_message_t state)
{
struct net_device *netdev = pci_get_drvdata(pdev);
struct e1000_adapter *adapter = netdev_priv(netdev);
uint32_t ctrl, ctrl_ext, rctl, manc, status, swsm;
uint32_t ctrl, ctrl_ext, rctl, manc, status;
uint32_t wufc = adapter->wol;
netif_device_detach(netdev);
......@@ -4251,21 +4307,9 @@ e1000_suspend(struct pci_dev *pdev, pm_message_t state)
}
}
switch(adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm & ~E1000_SWSM_DRV_LOAD);
break;
default:
break;
}
/* Release control of h/w to f/w. If f/w is AMT enabled, this
* would have already happened in close and is redundant. */
e1000_release_hw_control(adapter);
pci_disable_device(pdev);
pci_set_power_state(pdev, pci_choose_state(pdev, state));
......@@ -4278,8 +4322,7 @@ e1000_resume(struct pci_dev *pdev)
{
struct net_device *netdev = pci_get_drvdata(pdev);
struct e1000_adapter *adapter = netdev_priv(netdev);
uint32_t manc, ret_val, swsm;
uint32_t ctrl_ext;
uint32_t manc, ret_val;
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev);
......@@ -4304,21 +4347,13 @@ e1000_resume(struct pci_dev *pdev)
E1000_WRITE_REG(&adapter->hw, MANC, manc);
}
switch(adapter->hw.mac_type) {
case e1000_82571:
case e1000_82572:
ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT);
E1000_WRITE_REG(&adapter->hw, CTRL_EXT,
ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
break;
case e1000_82573:
swsm = E1000_READ_REG(&adapter->hw, SWSM);
E1000_WRITE_REG(&adapter->hw, SWSM,
swsm | E1000_SWSM_DRV_LOAD);
break;
default:
break;
}
/* If the controller is 82573 and f/w is AMT, do not set
* DRV_LOAD until the interface is up. For all other cases,
* let the f/w know that the h/w is now under the control
* of the driver. */
if (adapter->hw.mac_type != e1000_82573 ||
!e1000_check_mng_mode(&adapter->hw))
e1000_get_hw_control(adapter);
return 0;
}
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7