Merge tag 'mtk-mtd-spi-move' of...

Merge tag 'mtk-mtd-spi-move' of https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi into spi-5.7

spi: Rewrite mtk-quadspi spi-nor driver with spi-mem

This patchset from Chuanhong Guo <gch981213@gmail.com> adds a spi-mem
driver for Mediatek SPI-NOR controller, which already has limited
support by mtk-quadspi. This new driver can make use of full quadspi
capability of this controller.

Documentation/devicetree/bindings/mtd/mtk-quadspi.txt → Documentation/devicetree/bindings/spi/spi-mtk-nor.txt

-* Serial NOR flash controller for MediaTek SoCs
+* Serial NOR flash controller for MediaTek ARM SoCs
 
 Required properties:
 - compatible: 	  For mt8173, compatible should be "mediatek,mt8173-nor",
@@ -13,6 +13,7 @@ Required properties:
 		  "mediatek,mt7629-nor", "mediatek,mt8173-nor"
 		  "mediatek,mt8173-nor"
 - reg: 		  physical base address and length of the controller's register
+- interrupts:	  Interrupt number used by the controller.
 - clocks: 	  the phandle of the clocks needed by the nor controller
 - clock-names: 	  the names of the clocks
 		  the clocks should be named "spi" and "sf". "spi" is used for spi bus,
@@ -22,20 +23,16 @@ Required properties:
 - #address-cells: should be <1>
 - #size-cells:	  should be <0>
 
-The SPI flash must be a child of the nor_flash node and must have a
-compatible property. Also see jedec,spi-nor.txt.
-
-Required properties:
-- compatible:	  May include a device-specific string consisting of the manufacturer
-		  and name of the chip. Must also include "jedec,spi-nor" for any
-		  SPI NOR flash that can be identified by the JEDEC READ ID opcode (0x9F).
-- reg :		  Chip-Select number
+There should be only one spi slave device following generic spi bindings.
+It's not recommended to use this controller for devices other than SPI NOR
+flash due to limited transfer capability of this controller.
 
 Example:
 
 nor_flash: spi@1100d000 {
 	compatible = "mediatek,mt8173-nor";
 	reg = <0 0x1100d000 0 0xe0>;
+	interrupts = <&spi_flash_irq>;
 	clocks = <&pericfg CLK_PERI_SPI>,
 		 <&topckgen CLK_TOP_SPINFI_IFR_SEL>;
 	clock-names = "spi", "sf";

drivers/mtd/spi-nor/Kconfig

@@ -52,14 +52,6 @@ config SPI_HISI_SFC
 	help
 	  This enables support for HiSilicon FMC SPI-NOR flash controller.
 
-config SPI_MTK_QUADSPI
-	tristate "MediaTek Quad SPI controller"
-	depends on HAS_IOMEM
-	help
-	  This enables support for the Quad SPI controller in master mode.
-	  This controller does not support generic SPI. It only supports
-	  SPI NOR.
-
 config SPI_NXP_SPIFI
 	tristate "NXP SPI Flash Interface (SPIFI)"
 	depends on OF && (ARCH_LPC18XX || COMPILE_TEST)

drivers/mtd/spi-nor/Makefile

@@ -3,7 +3,6 @@ obj-$(CONFIG_MTD_SPI_NOR)	+= spi-nor.o
 obj-$(CONFIG_SPI_ASPEED_SMC)	+= aspeed-smc.o
 obj-$(CONFIG_SPI_CADENCE_QUADSPI)	+= cadence-quadspi.o
 obj-$(CONFIG_SPI_HISI_SFC)	+= hisi-sfc.o
-obj-$(CONFIG_SPI_MTK_QUADSPI)    += mtk-quadspi.o
 obj-$(CONFIG_SPI_NXP_SPIFI)	+= nxp-spifi.o
 obj-$(CONFIG_SPI_INTEL_SPI)	+= intel-spi.o
 obj-$(CONFIG_SPI_INTEL_SPI_PCI)	+= intel-spi-pci.o

drivers/spi/Kconfig

@@ -456,6 +456,16 @@ config SPI_MT7621
 	help
 	  This selects a driver for the MediaTek MT7621 SPI Controller.
 
+config SPI_MTK_NOR
+	tristate "MediaTek SPI NOR controller"
+	depends on ARCH_MEDIATEK || COMPILE_TEST
+	help
+	  This enables support for SPI NOR controller found on MediaTek
+	  ARM SoCs. This is a controller specifically for SPI-NOR flash.
+	  It can perform generic SPI transfers up to 6 bytes via generic
+	  SPI interface as well as several SPI-NOR specific instructions
+	  via SPI MEM interface.
+
 config SPI_NPCM_FIU
 	tristate "Nuvoton NPCM FLASH Interface Unit"
 	depends on ARCH_NPCM || COMPILE_TEST

drivers/spi/Makefile

@@ -65,6 +65,7 @@ obj-$(CONFIG_SPI_MPC52xx_PSC)		+= spi-mpc52xx-psc.o
 obj-$(CONFIG_SPI_MPC52xx)		+= spi-mpc52xx.o
 obj-$(CONFIG_SPI_MT65XX)                += spi-mt65xx.o
 obj-$(CONFIG_SPI_MT7621)		+= spi-mt7621.o
+obj-$(CONFIG_SPI_MTK_NOR)		+= spi-mtk-nor.o
 obj-$(CONFIG_SPI_MXIC)			+= spi-mxic.o
 obj-$(CONFIG_SPI_MXS)			+= spi-mxs.o
 obj-$(CONFIG_SPI_NPCM_FIU)		+= spi-npcm-fiu.o

drivers/spi/spi.c

@@ -1951,13 +1951,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
 		spi->mode |= SPI_CS_HIGH;
 
 	/* Device speed */
-	rc = of_property_read_u32(nc, "spi-max-frequency", &value);
-	if (rc) {
-		dev_err(&ctlr->dev,
-			"%pOF has no valid 'spi-max-frequency' property (%d)\n", nc, rc);
-		return rc;
-	}
-	spi->max_speed_hz = value;
+	if (!of_property_read_u32(nc, "spi-max-frequency", &value))
+		spi->max_speed_hz = value;
 
 	return 0;
 }