Commit b9763cdf authored by Marcel Holtmann's avatar Marcel Holtmann Committed by Johan Hedberg

Bluetooth: Introduce BT_HCIUART_RTL configuration option

Like all the other UART protocols, introduce a configuration option for
Realtek based serial devices.
Signed-off-by: default avatarMarcel Holtmann <marcel@holtmann.org>
Signed-off-by: default avatarHans de Goede <hdegoede@redhat.com>
Signed-off-by: default avatarJohan Hedberg <johan.hedberg@intel.com>
parent 7d2eb6de
......@@ -195,6 +195,19 @@ config BT_HCIUART_BCM
Say Y here to compile support for Broadcom protocol.
config BT_HCIUART_RTL
bool "Realtek protocol support"
depends on BT_HCIUART
depends on BT_HCIUART_SERDEV
depends on GPIOLIB
select BT_HCIUART_3WIRE
select BT_RTL
help
The Realtek protocol support enables Bluetooth HCI over 3-Wire
serial port internface for Realtek Bluetooth controllers.
Say Y here to compile support for Realtek protocol.
config BT_HCIUART_QCA
bool "Qualcomm Atheros protocol support"
depends on BT_HCIUART
......
......@@ -841,6 +841,7 @@ static void h5_serdev_remove(struct serdev_device *serdev)
hci_uart_unregister_device(&h5->serdev_hu);
}
#ifdef CONFIG_BT_HCIUART_RTL
static int h5_btrtl_setup(struct h5 *h5)
{
struct btrtl_device_info *btrtl_dev;
......@@ -922,10 +923,13 @@ static struct h5_vnd rtl_vnd = {
.close = h5_btrtl_close,
.acpi_gpio_map = acpi_btrtl_gpios,
};
#endif
#ifdef CONFIG_ACPI
static const struct acpi_device_id h5_acpi_match[] = {
#ifdef CONFIG_BT_HCIUART_RTL
{ "OBDA8723", (kernel_ulong_t)&rtl_vnd },
#endif
{ },
};
MODULE_DEVICE_TABLE(acpi, h5_acpi_match);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment