ARM: shmobile: r8a7790/lager dts: Add DVFS parameters into cpu0 node for r8a7790

Add needed information inside CPU0 for the generic cpufreq-cpu0 driver.

- voltage-tolerance = 1%
  It reflects the tolerance for the CPU voltage defined inside the OPP
  table. Due to the lack of proper OPP definition, use an arbitrary safe
  value.
- clock-latency = 300 us
  Approximate worst-case latency to do a full DVFS transition for every
  OPPs. Due to the lack of HW information, use an arbitrary safe value.
  Note: The term transition-latency will be more accurate to define this
  value since the clock transition latency is not the only parameter that
  will define the overall DVFS transition.
- operating-points = < kHz - uV >
  List of 6 operating points. All of them are using the same voltage
  since the valid Vmin voltage is not documented in the HW spec.
- clocks
  phandle to the CPU clock source. This clock source is used for all the
  4 CortexA15 located inside the same cluster.
Signed-off-by: Benoit Cousson <bcousson+renesas@baylibre.com>
[gaku.inami.xw@bp.renesas.com: Change the setting of OPPs for ES2.0]
Signed-off-by: Gaku Inami <gaku.inami.xw@bp.renesas.com>
Acked-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm/boot/dts/r8a7790-lager.dts

@@ -338,3 +338,7 @@ vdd_dvfs: regulator@68 {
 		regulator-always-on;
 	};
 };
+
+&cpu0 {
+	cpu0-supply = <&vdd_dvfs>;
+};

arch/arm/boot/dts/r8a7790.dtsi

@@ -44,6 +44,17 @@ cpu0: cpu@0 {
 			compatible = "arm,cortex-a15";
 			reg = <0>;
 			clock-frequency = <1300000000>;
+			voltage-tolerance = <1>; /* 1% */
+			clocks = <&cpg_clocks R8A7790_CLK_Z>;
+			clock-latency = <300000>; /* 300 us */
+
+			/* kHz - uV - OPPs unknown yet */
+			operating-points = <1400000 1000000>,
+					   <1225000 1000000>,
+					   <1050000 1000000>,
+					   < 875000 1000000>,
+					   < 700000 1000000>,
+					   < 350000 1000000>;
 		};
 
 		cpu1: cpu@1 {