powerpc/pci: Add calls to set_pcie_port_type() and set_pcie_hotplug_bridge()

We are missing these when building the pci_dev from scratch off
the Open Firmware device-tree
Signed-off-by: default avatarBenjamin Herrenschmidt <benh@kernel.crashing.org>
Acked-by: default avatarJesse Barnes <jbarnes@virtuousgeek.org>
parent b04da8bf
......@@ -140,6 +140,7 @@ struct pci_dev *of_create_pci_dev(struct device_node *node,
dev->devfn = devfn;
dev->multifunction = 0; /* maybe a lie? */
dev->needs_freset = 0; /* pcie fundamental reset required */
set_pcie_port_type(dev);
dev->vendor = get_int_prop(node, "vendor-id", 0xffff);
dev->device = get_int_prop(node, "device-id", 0xffff);
......@@ -164,6 +165,7 @@ struct pci_dev *of_create_pci_dev(struct device_node *node,
/* a PCI-PCI bridge */
dev->hdr_type = PCI_HEADER_TYPE_BRIDGE;
dev->rom_base_reg = PCI_ROM_ADDRESS1;
set_pcie_hotplug_bridge(dev);
} else if (!strcmp(type, "cardbus")) {
dev->hdr_type = PCI_HEADER_TYPE_CARDBUS;
} else {
......
......@@ -681,7 +681,7 @@ static void pci_read_irq(struct pci_dev *dev)
dev->irq = irq;
}
static void set_pcie_port_type(struct pci_dev *pdev)
void set_pcie_port_type(struct pci_dev *pdev)
{
int pos;
u16 reg16;
......@@ -695,7 +695,7 @@ static void set_pcie_port_type(struct pci_dev *pdev)
pdev->pcie_type = (reg16 & PCI_EXP_FLAGS_TYPE) >> 4;
}
static void set_pcie_hotplug_bridge(struct pci_dev *pdev)
void set_pcie_hotplug_bridge(struct pci_dev *pdev)
{
int pos;
u16 reg16;
......
......@@ -756,6 +756,10 @@ pci_power_t pci_target_state(struct pci_dev *dev);
int pci_prepare_to_sleep(struct pci_dev *dev);
int pci_back_from_sleep(struct pci_dev *dev);
/* For use by arch with custom probe code */
void set_pcie_port_type(struct pci_dev *pdev);
void set_pcie_hotplug_bridge(struct pci_dev *pdev);
/* Functions for PCI Hotplug drivers to use */
int pci_bus_find_capability(struct pci_bus *bus, unsigned int devfn, int cap);
#ifdef CONFIG_HOTPLUG
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment