Merge branch 'RTL8211E-RGMII-D'

Kunihiko Hayashi says:

====================
Change phy-mode to RGMII-ID to enable delay pins for RTL8211E

UniPhier PXs2, LD20, and PXs3 boards have RTL8211E ethernet phy, and the
phy have the RX/TX delays of RGMII interface using pull-ups on the RXDLY
and TXDLY pins.

After the commit bbc4d71d ("net: phy: realtek: fix rtl8211e rx/tx
delay config"), the delays are working correctly, however, "rgmii" means
no delay and the phy doesn't work. So need to set the phy-mode to
"rgmii-id" to show that RX/TX delays are enabled.

Changes since v1:
- Fix the commit message
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

arch/arm/boot/dts/uniphier-pxs2.dtsi

@@ -583,7 +583,7 @@ eth: ethernet@65000000 {
 			clocks = <&sys_clk 6>;
 			reset-names = "ether";
 			resets = <&sys_rst 6>;
-			phy-mode = "rgmii";
+			phy-mode = "rgmii-id";
 			local-mac-address = [00 00 00 00 00 00];
 			socionext,syscon-phy-mode = <&soc_glue 0>;
 

arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi

@@ -734,7 +734,7 @@ eth: ethernet@65000000 {
 			clocks = <&sys_clk 6>;
 			reset-names = "ether";
 			resets = <&sys_rst 6>;
-			phy-mode = "rgmii";
+			phy-mode = "rgmii-id";
 			local-mac-address = [00 00 00 00 00 00];
 			socionext,syscon-phy-mode = <&soc_glue 0>;
 

arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi

@@ -564,7 +564,7 @@ eth0: ethernet@65000000 {
 			clocks = <&sys_clk 6>;
 			reset-names = "ether";
 			resets = <&sys_rst 6>;
-			phy-mode = "rgmii";
+			phy-mode = "rgmii-id";
 			local-mac-address = [00 00 00 00 00 00];
 			socionext,syscon-phy-mode = <&soc_glue 0>;
 
@@ -585,7 +585,7 @@ eth1: ethernet@65200000 {
 			clocks = <&sys_clk 7>;
 			reset-names = "ether";
 			resets = <&sys_rst 7>;
-			phy-mode = "rgmii";
+			phy-mode = "rgmii-id";
 			local-mac-address = [00 00 00 00 00 00];
 			socionext,syscon-phy-mode = <&soc_glue 1>;