[ARM] 5037/1: Orion: fix DNS323/Kurobox Pro PCI initialisation

Whereas most Orion 5x machine support code would initialise the PCI
subsystem with nr_controllers in their struct hw_pci set to 2, the
DNS323 and Kurobox Pro machine support code had nr_controllers set
to 1.

This was presumably done because on those two machines, the PCI(-X)
controller (nr == 1) isn't used, requiring initialisation of only
the PCIe controller (nr == 0.)  However, not initialising the PCI(-X)
controller on boards that don't use it leads to a situation where
both the PCIe and the PCI(-X) controller think that their root bus is
zero, and it messes up IRQ assignment.

This patch changes the DNS323 and Kurobox Pro support code to always
use nr_controllers == 2.
Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

arch/arm/mach-orion5x/dns323-setup.c

@@ -58,7 +58,7 @@ static int __init dns323_pci_map_irq(struct pci_dev *dev, u8 slot, u8 pin)
 }
 
 static struct hw_pci dns323_pci __initdata = {
-	.nr_controllers = 1,
+	.nr_controllers = 2,
 	.swizzle	= pci_std_swizzle,
 	.setup		= orion5x_pci_sys_setup,
 	.scan		= orion5x_pci_sys_scan_bus,

arch/arm/mach-orion5x/kurobox_pro-setup.c

@@ -138,7 +138,7 @@ static int __init kurobox_pro_pci_map_irq(struct pci_dev *dev, u8 slot, u8 pin)
 }
 
 static struct hw_pci kurobox_pro_pci __initdata = {
-	.nr_controllers	= 1,
+	.nr_controllers	= 2,
 	.swizzle	= pci_std_swizzle,
 	.setup		= orion5x_pci_sys_setup,
 	.scan		= orion5x_pci_sys_scan_bus,