ath9k: Revamp RX handling

Remove a lot of old, crufty code and make
RX status reporting a bit sane and clean.

Do not do anything to the RX skb before unmapping.
So in ath_rx_tasklet(), move the skb_put() after PCI unmap.
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/ath9k/core.h

@@ -279,13 +279,6 @@ struct ath_descdma {
 	dma_addr_t dd_dmacontext;
 };
 
-/* Abstraction of a received RX MPDU/MMPDU, or a RX fragment */
-
-struct ath_rx_context {
-	struct ath_buf *ctx_rxbuf;	/* associated ath_buf for rx */
-};
-#define ATH_RX_CONTEXT(skb) ((struct ath_rx_context *)skb->cb)
-
 int ath_descdma_setup(struct ath_softc *sc,
 		      struct ath_descdma *dd,
 		      struct list_head *head,
@@ -298,61 +291,21 @@ void ath_descdma_cleanup(struct ath_softc *sc,
 			 struct ath_descdma *dd,
 			 struct list_head *head);
 
-/******/
-/* RX */
-/******/
+/***********/
+/* RX / TX */
+/***********/
 
 #define ATH_MAX_ANTENNA          3
 #define ATH_RXBUF                512
 #define WME_NUM_TID              16
 
-/* per frame rx status block */
-struct ath_recv_status {
-	u64 tsf;		/* mac tsf */
-	int8_t rssi;		/* RSSI (noise floor ajusted) */
-	int8_t rssictl[ATH_MAX_ANTENNA];	/* RSSI (noise floor ajusted) */
-	int8_t rssiextn[ATH_MAX_ANTENNA];	/* RSSI (noise floor ajusted) */
-	int8_t abs_rssi;	/* absolute RSSI */
-	u8 rateieee;		/* data rate received (IEEE rate code) */
-	u8 ratecode;		/* phy rate code */
-	int rateKbps;		/* data rate received (Kbps) */
-	int antenna;		/* rx antenna */
-	int flags;		/* status of associated skb */
-#define ATH_RX_FCS_ERROR        0x01
-#define ATH_RX_MIC_ERROR        0x02
-#define ATH_RX_DECRYPT_ERROR    0x04
-#define ATH_RX_RSSI_VALID       0x08
-/* if any of ctl,extn chainrssis are valid */
-#define ATH_RX_CHAIN_RSSI_VALID 0x10
-/* if extn chain rssis are valid */
-#define ATH_RX_RSSI_EXTN_VALID  0x20
-/* set if 40Mhz, clear if 20Mhz */
-#define ATH_RX_40MHZ            0x40
-/* set if short GI, clear if full GI */
-#define ATH_RX_SHORT_GI         0x80
-};
-
-struct ath_rxbuf {
-	struct sk_buff *rx_wbuf;
-	unsigned long rx_time;			/* system time when received */
-	struct ath_recv_status rx_status;	/* cached rx status */
-};
-
 int ath_startrecv(struct ath_softc *sc);
 bool ath_stoprecv(struct ath_softc *sc);
 void ath_flushrecv(struct ath_softc *sc);
 u32 ath_calcrxfilter(struct ath_softc *sc);
-void ath_handle_rx_intr(struct ath_softc *sc);
 int ath_rx_init(struct ath_softc *sc, int nbufs);
 void ath_rx_cleanup(struct ath_softc *sc);
 int ath_rx_tasklet(struct ath_softc *sc, int flush);
-int _ath_rx_indicate(struct ath_softc *sc,
-		     struct sk_buff *skb,
-		     struct ath_recv_status *status,
-		     u16 keyix);
-/******/
-/* TX */
-/******/
 
 #define ATH_TXBUF               512
 /* max number of transmit attempts (tries) */

drivers/net/wireless/ath9k/main.c

@@ -236,68 +236,6 @@ static void setup_ht_cap(struct ieee80211_sta_ht_cap *ht_info)
 	ht_info->mcs.tx_params = IEEE80211_HT_MCS_TX_DEFINED;
 }
 
-static int ath_rate2idx(struct ath_softc *sc, int rate)
-{
-	int i = 0, cur_band, n_rates;
-	struct ieee80211_hw *hw = sc->hw;
-
-	cur_band = hw->conf.channel->band;
-	n_rates = sc->sbands[cur_band].n_bitrates;
-
-	for (i = 0; i < n_rates; i++) {
-		if (sc->sbands[cur_band].bitrates[i].bitrate == rate)
-			break;
-	}
-
-	/*
-	 * NB:mac80211 validates rx rate index against the supported legacy rate
-	 * index only (should be done against ht rates also), return the highest
-	 * legacy rate index for rx rate which does not match any one of the
-	 * supported basic and extended rates to make mac80211 happy.
-	 * The following hack will be cleaned up once the issue with
-	 * the rx rate index validation in mac80211 is fixed.
-	 */
-	if (i == n_rates)
-		return n_rates - 1;
-	return i;
-}
-
-static void ath9k_rx_prepare(struct ath_softc *sc,
-			     struct sk_buff *skb,
-			     struct ath_recv_status *status,
-			     struct ieee80211_rx_status *rx_status)
-{
-	struct ieee80211_hw *hw = sc->hw;
-	struct ieee80211_channel *curchan = hw->conf.channel;
-
-	memset(rx_status, 0, sizeof(struct ieee80211_rx_status));
-
-	rx_status->mactime = status->tsf;
-	rx_status->band = curchan->band;
-	rx_status->freq =  curchan->center_freq;
-	rx_status->noise = sc->sc_ani.sc_noise_floor;
-	rx_status->signal = rx_status->noise + status->rssi;
-	rx_status->rate_idx = ath_rate2idx(sc, (status->rateKbps / 100));
-	rx_status->antenna = status->antenna;
-
-	/* at 45 you will be able to use MCS 15 reliably. A more elaborate
-	 * scheme can be used here but it requires tables of SNR/throughput for
-	 * each possible mode used. */
-	rx_status->qual = status->rssi * 100 / 45;
-
-	/* rssi can be more than 45 though, anything above that
-	 * should be considered at 100% */
-	if (rx_status->qual > 100)
-		rx_status->qual = 100;
-
-	if (status->flags & ATH_RX_MIC_ERROR)
-		rx_status->flag |= RX_FLAG_MMIC_ERROR;
-	if (status->flags & ATH_RX_FCS_ERROR)
-		rx_status->flag |= RX_FLAG_FAILED_FCS_CRC;
-
-	rx_status->flag |= RX_FLAG_TSFT;
-}
-
 static void ath9k_ht_conf(struct ath_softc *sc,
 			  struct ieee80211_bss_conf *bss_conf)
 {
@@ -440,44 +378,6 @@ void ath_tx_complete(struct ath_softc *sc, struct sk_buff *skb,
 	ieee80211_tx_status(hw, skb);
 }
 
-int _ath_rx_indicate(struct ath_softc *sc,
-		     struct sk_buff *skb,
-		     struct ath_recv_status *status,
-		     u16 keyix)
-{
-	struct ieee80211_hw *hw = sc->hw;
-	struct ieee80211_rx_status rx_status;
-	struct ieee80211_hdr *hdr = (struct ieee80211_hdr *) skb->data;
-	int hdrlen = ieee80211_get_hdrlen_from_skb(skb);
-	int padsize;
-
-	/* see if any padding is done by the hw and remove it */
-	if (hdrlen & 3) {
-		padsize = hdrlen % 4;
-		memmove(skb->data + padsize, skb->data, hdrlen);
-		skb_pull(skb, padsize);
-	}
-
-	/* Prepare rx status */
-	ath9k_rx_prepare(sc, skb, status, &rx_status);
-
-	if (!(keyix == ATH9K_RXKEYIX_INVALID) &&
-	    !(status->flags & ATH_RX_DECRYPT_ERROR)) {
-		rx_status.flag |= RX_FLAG_DECRYPTED;
-	} else if ((le16_to_cpu(hdr->frame_control) & IEEE80211_FCTL_PROTECTED)
-		   && !(status->flags & ATH_RX_DECRYPT_ERROR)
-		   && skb->len >= hdrlen + 4) {
-		keyix = skb->data[hdrlen + 3] >> 6;
-
-		if (test_bit(keyix, sc->sc_keymap))
-			rx_status.flag |= RX_FLAG_DECRYPTED;
-	}
-
-	__ieee80211_rx(hw, skb, &rx_status);
-
-	return 0;
-}
-
 /********************************/
 /*	 LED functions		*/
 /********************************/