Commit c29c3ba5 authored by Bruce Allan's avatar Bruce Allan Committed by Jeff Kirsher

e1000e: cleanup LONG_LINE checkpatch warnings

WARNING:LONG_LINE: line over 80 characters
Signed-off-by: default avatarBruce Allan <bruce.w.allan@intel.com>
Tested-by: default avatarAaron Brown <aaron.f.brown@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
parent 362e20ca
......@@ -66,7 +66,7 @@
#define E1000_CTRL_EXT_LINK_MODE_PCIE_SERDES 0x00C00000
#define E1000_CTRL_EXT_EIAME 0x01000000
#define E1000_CTRL_EXT_DRV_LOAD 0x10000000 /* Driver loaded bit for FW */
#define E1000_CTRL_EXT_IAME 0x08000000 /* Interrupt acknowledge Auto-mask */
#define E1000_CTRL_EXT_IAME 0x08000000 /* Int ACK Auto-mask */
#define E1000_CTRL_EXT_PBA_CLR 0x80000000 /* PBA Clear */
#define E1000_CTRL_EXT_LSECCK 0x00001000
#define E1000_CTRL_EXT_PHYPDEN 0x00100000
......@@ -239,7 +239,7 @@
#define E1000_STATUS_SPEED_1000 0x00000080 /* Speed 1000Mb/s */
#define E1000_STATUS_LAN_INIT_DONE 0x00000200 /* Lan Init Completion by NVM */
#define E1000_STATUS_PHYRA 0x00000400 /* PHY Reset Asserted */
#define E1000_STATUS_GIO_MASTER_ENABLE 0x00080000 /* Status of Master requests. */
#define E1000_STATUS_GIO_MASTER_ENABLE 0x00080000 /* Master Req status */
#define HALF_DUPLEX 1
#define FULL_DUPLEX 2
......@@ -400,7 +400,8 @@
#define E1000_ICR_RXDMT0 0x00000010 /* Rx desc min. threshold (0) */
#define E1000_ICR_RXT0 0x00000080 /* Rx timer intr (ring 0) */
#define E1000_ICR_ECCER 0x00400000 /* Uncorrectable ECC Error */
#define E1000_ICR_INT_ASSERTED 0x80000000 /* If this bit asserted, the driver should claim the interrupt */
/* If this bit asserted, the driver should claim the interrupt */
#define E1000_ICR_INT_ASSERTED 0x80000000
#define E1000_ICR_RXQ0 0x00100000 /* Rx Queue 0 Interrupt */
#define E1000_ICR_RXQ1 0x00200000 /* Rx Queue 1 Interrupt */
#define E1000_ICR_TXQ0 0x00400000 /* Tx Queue 0 Interrupt */
......@@ -583,12 +584,12 @@
#define E1000_EECD_SEC1VAL 0x00400000 /* Sector One Valid */
#define E1000_EECD_SEC1VAL_VALID_MASK (E1000_EECD_AUTO_RD | E1000_EECD_PRES)
#define E1000_NVM_RW_REG_DATA 16 /* Offset to data in NVM read/write registers */
#define E1000_NVM_RW_REG_DATA 16 /* Offset to data in NVM r/w regs */
#define E1000_NVM_RW_REG_DONE 2 /* Offset to READ/WRITE done bit */
#define E1000_NVM_RW_REG_START 1 /* Start operation */
#define E1000_NVM_RW_ADDR_SHIFT 2 /* Shift to the address bits */
#define E1000_NVM_POLL_WRITE 1 /* Flag for polling for write complete */
#define E1000_NVM_POLL_READ 0 /* Flag for polling for read complete */
#define E1000_NVM_POLL_WRITE 1 /* Flag for polling write complete */
#define E1000_NVM_POLL_READ 0 /* Flag for polling read complete */
#define E1000_FLASH_UPDATES 2000
/* NVM Word Offsets */
......
......@@ -558,12 +558,14 @@ static inline s32 e1000e_update_nvm_checksum(struct e1000_hw *hw)
return hw->nvm.ops.update(hw);
}
static inline s32 e1000_read_nvm(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
static inline s32 e1000_read_nvm(struct e1000_hw *hw, u16 offset, u16 words,
u16 *data)
{
return hw->nvm.ops.read(hw, offset, words, data);
}
static inline s32 e1000_write_nvm(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
static inline s32 e1000_write_nvm(struct e1000_hw *hw, u16 offset, u16 words,
u16 *data)
{
return hw->nvm.ops.write(hw, offset, words, data);
}
......
......@@ -549,7 +549,8 @@ static int e1000_set_eeprom(struct net_device *netdev,
if (eeprom->len == 0)
return -EOPNOTSUPP;
if (eeprom->magic != (adapter->pdev->vendor | (adapter->pdev->device << 16)))
if (eeprom->magic !=
(adapter->pdev->vendor | (adapter->pdev->device << 16)))
return -EFAULT;
if (adapter->flags & FLAG_READ_ONLY_NVM)
......
......@@ -6918,7 +6918,8 @@ static DEFINE_PCI_DEVICE_TABLE(e1000_pci_tbl) = {
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_COPPER), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_FIBER), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_QUAD_COPPER), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_QUAD_COPPER_LP), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_QUAD_COPPER_LP),
board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_QUAD_FIBER), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_SERDES), board_82571 },
{ PCI_VDEVICE(INTEL, E1000_DEV_ID_82571EB_SERDES_DUAL), board_82571 },
......
......@@ -143,7 +143,8 @@ E1000_PARAM(KumeranLockLoss, "Enable Kumeran lock loss workaround");
*
* Default Value: 1 (enabled)
*/
E1000_PARAM(WriteProtectNVM, "Write-protect NVM [WARNING: disabling this can lead to corrupted NVM]");
E1000_PARAM(WriteProtectNVM,
"Write-protect NVM [WARNING: disabling this can lead to corrupted NVM]");
/* Enable CRC Stripping
*
......@@ -500,7 +501,8 @@ void e1000e_check_options(struct e1000_adapter *adapter)
if (adapter->flags & FLAG_IS_ICH) {
if (num_WriteProtectNVM > bd) {
unsigned int write_protect_nvm = WriteProtectNVM[bd];
unsigned int write_protect_nvm =
WriteProtectNVM[bd];
e1000_validate_option(&write_protect_nvm, &opt,
adapter);
if (write_protect_nvm)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment